Electronics Forum | Thu Mar 11 11:08:22 EST 2010 | geocep
I am using AIM Electropure SN63/Pb37 Solder, & AIM NC266-3 Flux; just like what ACE recommends. I have both Ultra High Pure T-Tanks and a Cryogenic Dewar Tank for Nitrogen, and neither seems to have improved the problem. I place a piece of tempered
Electronics Forum | Tue Jun 21 21:54:34 EDT 2005 | Zeta
PCB BOARD - After removal of the BGA from the PCBA. In the midst of removal of the solder at the PCB, the green mask was scratched. If we do not repair the green mask, the whole board will have to be scrapped. Which repair kit do you recommend. W
Electronics Forum | Thu Oct 05 13:00:54 EDT 2006 | Mario Scalzo, SMT CPE
Good afternoon! We have a Hand Assembly & Rework Pb-Free RoHS compliant kit available! Please email me offline. Should you have any further questions, please don't hesitate to ask. My contact information is below. Regards, Mario Scalzo, SMT CPE
Electronics Forum | Fri Mar 15 15:11:08 EST 2002 | clarkk
Check out http://www.circuittechctr.com/index.htm They have kits and training for making pcb mods. And no, I don't work for them. But they have saved my butt once or twice with handy repairs for damaged pcb's. Good luck!
Electronics Forum | Mon Oct 02 05:51:46 EDT 2006 | dave
All, What controls do you have in place for PCB moisture control? If you had a kit of 400 and you ran out of a part which wasnot due in until 6 weeks- do you store the boards in a dry cabinet ? Vacuum seal and store on a rack? Alan...
Electronics Forum | Wed Sep 27 15:41:34 EDT 2006 | russ
Why yes you do!!! Now you know if you make someone put RoHS compliant on their packaging that we will have to pay more for the same product right? hahaha I am not aware of anyone that has this published claim. Good Luck Russ
Electronics Forum | Fri Oct 06 11:34:56 EDT 2006 | Yorgen
i am using RE-7500 from Jovy Systems... they write on the machine "Lead Free Combaible" , you can check www.jovy-systems.com
Electronics Forum | Wed Jul 13 13:23:34 EDT 2011 | kkay
We have multuiple pcb transport conveyors that use the 10mm wide flat green blets on either edge. Does anyone know of a kit to purchase where we could make our own or a company that supplies different sizes? Thanks
Electronics Forum | Fri Mar 12 11:53:47 EST 2004 | Dreamsniper
Thanks Dave...it's such a good site for reworking BGA's (reballing). But what about when it comes to re-attaching the BGA onto the PCB? We are using Flextac Stencils but I found out that the apertures of their stencil is bigger than our pads for the
Electronics Forum | Wed Jan 06 23:59:37 EST 1999 | Andy
| | If passive componets are cheaper why aren't they more popular? Manufacturers like Murata and AVX claim availability and substantial cost savings but little interest seems to exist. Why? Your input is greatly appreciated. | | | Because people ju
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
