Electronics Forum | Sat Jan 28 13:28:15 EST 2006 | eeltec
Dear All: I am learning to program a Philips Comet GEM Machine with VIOS. I am programming a simple PCB that has 300 components but just 3 part numbers so I want to build a complete board in each table of the machine (A and B) and until now I have no
Electronics Forum | Sun Jul 05 12:32:43 EDT 2009 | emanuel
While moving to a new location we had to remove the tables from a Philips Comet in order to be able to pass a narrow door. While attempting to calibrate the machine, during Warm-Up a strange error appears, sometimes almost immediately and sometimes a
Electronics Forum | Wed Dec 07 02:35:28 EST 2011 | mk15
Hi, I am looking for help with Error Philips Comet, Start Procedure -OK, INTIAL SERVO ORIGIN -OK, AUTORUNNING -OK, PCB START -OK, FIDUCIAL -OK, PICKUPCOMPONENT -OK, NEXT-ERROR E2 CORRECTION DATA ERROR(CORRECTION DATA IS NOT LOADED OR FAILED TO ADJU
Electronics Forum | Sun Jan 29 13:43:33 EST 2006 | eeltec
I am looking for a service of programming "off line" a Philips Comet Machine that has VIOS. If someone can do this or can recommend me someone please email to gb@ieee.org Greg
Electronics Forum | Thu Oct 06 14:33:46 EDT 2005 | Cmiller
The software you downloaded is not what you need. I can e-mail you a version of Philips cad to cad converter V1.5. We use it for Comet and Topaz machines. Send me an e-mail and I will forward it to you. cmiller@adltech.com
Electronics Forum | Fri Sep 16 12:00:43 EDT 2005 | SuMoTe
Using Circuit Cam here. Not sure on the cost though. We use it to program our CS400E insertion machines as well. Makes nice work instruction drawings too.
Electronics Forum | Wed Sep 21 05:26:58 EDT 2005 | Base
Lasse: Rich beat me to it! His steps are the correct ones. You first need to put your CAD-data into a column file and then use CAD2CAD to import, process and export it as VIOStxt. Greetings Base
Electronics Forum | Thu Oct 06 18:26:35 EDT 2005 | Lasse H.
Thanks for the help, but I allready got the software and it is wirking quite good... I really apreciate the help you all have giving me... I definitly gonna use this site again ,when i run into truble... Best Regards Lasse Husman
Electronics Forum | Thu Jul 09 13:19:38 EDT 2009 | emanuel
Just in case somebody will bump in the same situation and looks for a possible solution, the problem was with a small 2 pin connector that feeds one of the W DC motors. The connector looked ok, but one of the pins pulled a little out and was making
Electronics Forum | Wed Dec 07 11:12:17 EST 2011 | thanh
go to Components Info. F4 to Pick & Mount Info scrool down to Mount Action change to Normal instead of Fine.
