Electronics Forum | Tue Sep 13 04:58:57 EDT 2011 | Jacki
Dear Mosborne Thanks for your knid advice. Yap, now I posted 2 photos showing the solder condition before and after wave soldering. Just reminding, the board in the photos had been already soldering in Reflow Process. Hope, you guys will have more a
Electronics Forum | Fri Jun 10 08:08:54 EDT 2005 | ajaydoshi
thanks a lot for info. If you have some photo, pl. send at ajay_doshi@utlindia.com Photo will help to understand better ajay
Electronics Forum | Thu Jan 29 15:06:42 EST 2009 | padawanlinuxero
http://www.flickr.com/photos/94427924@N00/3236723528/ and 94427924@N00/3235878901/" target="_blank">http://www.flickr.com/photos/94427924@N00/3235878901/ do you guys think these is a finish problem ?
Electronics Forum | Mon Jul 11 15:30:52 EDT 2011 | dmiller
Take a picture of one that just barely meets specs. Take a photo of this, either under a scope or with one of those USB scopes. Then use the photo for whatever instructions you provide to the operators.
Electronics Forum | Mon Jan 09 12:41:31 EST 2023 | proceng1
Magyart is on the right track. Lots of variables. Can you post a photo of the skewed part? But also, is it skewed in the paste before reflow? How many inductors are doing this per board? Lastly, indicate on the photo the direction of travel in the
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Fri Nov 22 00:09:29 EST 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem. 1. after hardware initiation appear - F-MOT-MOVE X/250: Motor speed out of control (photo1). 2. in service mode when x motor initiate appear - F-MOT-MSETDYN X/12: No axis movemen
Electronics Forum | Mon Sep 19 13:40:52 EDT 2005 | russ
I believe Photo Stencil / AMTX can do these well.