Electronics Forum | Wed Feb 13 18:13:58 EST 2019 | slthomas
I'm trying to visualize how that machine is laid out. Do they all rotate together, on a belt, so that there's only one sensor for the theta (R) home position?
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
Electronics Forum | Mon Jun 20 18:36:42 EDT 2005 | jsloot
Does anyone have any experience with a QUAD Meridian 1010? Our company has purchased a used machine. We have it installed and running almost smoothly. Getting an error code 3487, description is "Z axis target position in motion board is strange" Anyo
Electronics Forum | Mon Jul 28 18:31:43 EDT 2003 | mantis
Hi There, First has the machine in question had the camera upgraded to accomdate 0603/0402. It sounds like there is a bad pickup on this part.Are all nozzles ok is feeder indexing correctly has part pick up position(Station 1) been calibrated. Hope t
Electronics Forum | Fri Sep 26 08:11:15 EDT 2008 | dwelch123
Try swapping cards in Y1 enclosure. You can swap zero and one or two and three but make sure you change the shunt position and the dip switch settings and see if your problem switches cards. The lithium battery likes to fail on those cards. Reload th
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat
Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban
Electronics Forum | Thu May 21 23:18:22 EDT 2020 | gabriel1blue
After the closing down for a few weeks we encountered a problem with our old pick and place machine. It reset to Japanese but we were able to change it back to English. Not when we start the machine and try to get it back to origin we get a counter o
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Thu Jun 08 18:40:44 EDT 2017 | simons
We have a Samsung that we have replaced all the amps and are still getting the Z axis motor alarm failure. On the “Position Window” before and after we try to “Home” the machine, the values for “Z-Axis” for all three heads prior to the “Home” action