Electronics Forum | Wed May 31 04:55:39 EDT 2006 | Rob
No one really does the complete line - they may supply it, but the ovens & usually the printers will be badged - so you end up compromising on at least one machine to get them all from the same supplier. If you buy a Speedprint printer, fuji P&P, an
Electronics Forum | Wed Dec 22 13:04:41 EST 2010 | wingding
I have a FUJI MCS-30 and no way to print from it. I need a cable that goes from the printer to the connector on the back of the computer, or an adaptor that will allow me to use my dot matrix printer. The printer is new so I don’t want to replace it
Electronics Forum | Thu Sep 14 14:50:08 EDT 2006 | gillmore
I am need of one or all of the following items of literature for a Fuji GP551E Screen Printer: Operating Manual Maintenance Manual Schematic Parts List
Electronics Forum | Tue May 29 07:24:07 EDT 2012 | cyber_wolf
There were some issues with the older grid-lok systems that have been resolved in the newer designs. We run them in all of our printers and Fuji chip shooters. The only issue we see is that the air pressure may need adjusted on thin boards.
Electronics Forum | Mon Nov 29 13:01:35 EST 2004 | bobsavenger
I have a DEK 265LT screen printer and a Fuji bare board loader. I cannot get the two machines to talk through the SMEMA cable. I have the personality card for the DEK and I have the correct cable for a FUJI machine. Is there something that I nee
Electronics Forum | Mon Jul 13 19:15:33 EDT 1998 | James Vaughn
What frame is used in the FUJI 641 printer? What offset dimension is used from the leading edge of the frame? Thanks for any help on this subject.
Electronics Forum | Wed Jul 15 12:19:09 EDT 1998 | Steve
| What frame is used in the FUJI 641 printer? What offset dimension is used from the leading edge of the frame? Thanks for any help on this subject. HI JIM
Electronics Forum | Wed Jul 15 19:32:22 EDT 1998 | Eric
| | What frame is used in the FUJI 641 printer? What offset dimension is used from the leading edge of the frame? Thanks for any help on this subject. | HI JIM Hi Steve and Jim!
Electronics Forum | Fri Oct 25 14:46:50 EDT 2002 | russ
Leading edge, This is used to determine the orientation of the board as you want to run it. If you use center justified stencils this is usually not an issue since you can just turn the stencil any which way you want to. If you are using front/rear
Electronics Forum | Fri Feb 27 09:14:40 EST 2004 | cyber_wolf
To simplify; Can I take a 20X20 stencil with a centered image off my shelf and drop it into a DEK printer. OR...Does DEK require a special stencil like Fuji's do ?