Electronics Forum | Sat Feb 02 14:19:16 EST 2013 | bangerla
Could someone provide the size or source for the o-rings on the z rod of a Quad IVC, which hold the nozzle?
Electronics Forum | Wed Sep 20 15:25:15 EDT 2006 | lheiss
Hey All, Thanks for all of your help to date. While running the nozzle height test I noticed that the Z-rod is bent. Probably happened after setting the "X closed loop soft home" back to 50 from 384 which was probably why the nozzle slammed into t
Electronics Forum | Wed Sep 20 18:07:52 EDT 2006 | lheiss
It wasn't my idea to reset all the mod codes. I was just doing what the guy on the other end of the phone said. I'm working on straighting the Z-Rod now and have a new one on the way as well as a grease kit. I've only checked with one company on d
Electronics Forum | Thu Jul 31 07:28:04 EDT 2008 | leemeyer
This sounds like a Quadalign problem. Upon startup the Quadalign system checks runout of the Z-rod and tries to find the tip of the nozzle. It will keep lowering the Z-rod and looking for the tip until it hits it's limit. Check and see if the Quadali
Electronics Forum | Thu Aug 16 07:40:27 EDT 2012 | bobpan
Here are a couple of things to look at. 1. Watch the machine run....and if it misses a part....make sure it doesnt blow out the next part being presented. Sometimes the air pressure is too high and the vacuum verify will blow the part out of the poc
Electronics Forum | Fri Aug 30 11:31:29 EDT 2013 | nophsem
We have two QUAD 4C working in tandem. 3 months ago the EPCU battery (QUAD # 2) died, then we change it. Then downloaded the MODs from the controller to the assembler(does simultaneously on both machines). All this time we continue to work normally.
Electronics Forum | Mon Mar 14 09:24:38 EST 2005 | Steve C.
Also check the z-rod and make sure it is not compressed.
Electronics Forum | Mon Mar 14 09:57:06 EST 2005 | Micheal
z-rod is in very good condition.
Electronics Forum | Mon Mar 16 06:12:32 EDT 2015 | bobpan
The first thing to do is to change the z-rod. Sometimes a very old z-rod spring will weaken causing it to reject many parts. If it only rejects parts after a nozzle change....you may need to put some super lube grease on the O-rings on the bottom of
Electronics Forum | Sun May 11 17:29:17 EDT 2014 | bobpan
Most times when the machine oscillates when closing the doors it will be a problem with the digital i/o cards. I would check that the dip switch settings are correct. If they are correct i would look at replacing both of the cards. The boards are sub