Electronics Forum | Wed Feb 20 16:03:19 EST 2013 | bocci572
I am wondering if anyone has had issues with their Heller oven rails warping. It appears that our 1800EXL and 1900W oven rails sag after time. They eventually contact the safety mesh and then create hestitation of the chain, thus creating defects.
Electronics Forum | Fri Jun 04 04:10:52 EDT 2010 | leeg
Have you checked the Rail Lifted Sensor
Electronics Forum | Mon Jun 19 10:46:53 EDT 2000 | D.J.
Does anyone out there have a Vitronics SMR400 or SMR410? Trying to get facilities specifications for amperage at 208 vac, and also any information for rail adjustment procedure for dual rail. Did Vitronics offer fixed tooling rail adjustment, are t
Electronics Forum | Mon Jun 19 10:46:41 EDT 2000 | D.J.
Does anyone out there have a Vitronics SMR400 or SMR410? Trying to get facilities specifications for amperage at 208 vac, and also any information for rail adjustment procedure for dual rail. Did Vitronics offer fixed tooling rail adjustment, are t
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Wed Apr 09 03:32:49 EDT 2014 | sarason
Place a Digital CRO on that 24V rail. Watch the output. trigger on voltage drop lets say 18V picking a figure out of the air. You may well have another rail in your supply or nearby pulling your 240V //110V rail. Most likely a shot Electro either on
Electronics Forum | Thu Feb 21 06:18:42 EST 2013 | cbeneat
We run 3 Vitronics XPM2's, our newest is 3 years, oldest is 6+ and I have not seen our rails warp the way you're describing. I would be plenty frustrated if I had to replace rails this often.
Electronics Forum | Mon Apr 09 11:39:32 EDT 2018 | emeto
The easiest way to do without special tools is to use level. Check machine co-planarity on the conveyor rails in both directions(you can do that with rails down or rails up or both). Then check co-planarity on the stencil. If the level shows the sam
Electronics Forum | Wed Feb 27 11:20:15 EST 2013 | marcpeo
Sorry to hear of the difficulty with the rails on these systems. The 2 machines mentioned are 10 years old or more. The rails typcially last quite a while but replacement after 10 years is possible. Please feel free to e-mail me directly to discus
Electronics Forum | Wed Jan 17 07:58:31 EST 2018 | lokiz
Greetings, I have been told that auto rail width with the Samsung SM320 is a purchased option opposed to a standard feature. What I would like to know is what all comes in the auto rail width kit. It looks to me like the wire harness where the rai