Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat
Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban
Electronics Forum | Tue Feb 12 12:32:45 EST 2019 | aldrich17
Your response is helpful to a point. But unfortunately i can not confirm where the sensor is as i do not know what the A-table is. But i have checked sensors that i know of and one was not giving off a signal and fixed that issue. But now i am experi
Electronics Forum | Thu Jan 03 15:53:28 EST 2019 | cbeneat
We did figure out the issue. The plastic cover inside the LED lighting unit had a slight film covering it, which made the picture slightly hazy. We had to disassemble the LED module to get at it, cleaned it and it was fine. I didn't think this would
Electronics Forum | Tue Feb 12 12:14:57 EST 2019 | slthomas
I haven't worked on a Topaz of any sort in over 10 years but I'm going to guess that even if you accessed that table, you would see a 0 someplace that you should be seeing a 1. It sounds like *maybe* an input signal from that sensor is not reaching
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Wed Jun 12 09:37:13 EDT 2019 | key
We have a Dek 248 that when the table goes in it will not come out. We tested up/down sensors they are fine. The in and out sensors work in diagnostic. when we try to abort the unit the table should come out but doesn't. Any help would be great and a
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Sat Sep 28 15:58:38 EDT 2013 | sonavc
Hi. 'm new to this Fuji CP3, I bought this machine in working condition ( I saw it ran, but I forgot to check the board in and out ).... Moved to my location, Problem: When the board is trying to load to the X-Y table, it passed the conveyor B but
.gif)
