Electronics Forum | Mon Feb 14 21:31:08 EST 2022 | stephendo
And you can see at least a little through them. That can be a slight advantage as well.
Electronics Forum | Thu Sep 22 18:23:14 EDT 2005 | arnie
Hi, I am having a problem with component position on a flex circuit. It is an eight up panel. The flex circuit is mounted on to a piece of fr4 with presure sensitive adhiesive, this is done out of house. The problem is, I will locate the parts on one
Electronics Forum | Tue Oct 05 15:21:48 EDT 2010 | mikesewell
Nothing wrong with using RoHS BGAs except that the spheres won't melt/collapse at normal leaded reflow temps. Reliability will questionable. Some people use a hybrid profile with a slightly higher temp (~230C)and a slightly longer TAL (60 -90 sec).
Electronics Forum | Tue Jul 25 20:46:01 EDT 2000 | Dave F
Vicki: The other responders make good points. Taking a slightly different, slightly more aggressive tact, you might try something like this: * Click on ... http://www.ssafl.com/bat_prod.htm ... and buy a unit of the proper size to fit your stature
Electronics Forum | Wed May 29 17:17:49 EDT 2002 | wilcoxito
As far as aperture dimensions go, I found a technical note written by Micron that recommends using "square apertures with sides equal in length to the diameter of the PCB pad. The corners of the square should also be slightly rounded, and the apertu
Electronics Forum | Sat Mar 29 13:35:32 EST 2003 | MA/NY DDave
Hi Back later on this tread, yet I did want to slightly correct one thing DaveyF wrote. Again only slightly. Even at 90C, moisture does start to leave the board. Now it doesn't do it so well as above 100C at sea level atmospheric pressure, yet it s
Electronics Forum | Thu Jan 03 15:53:28 EST 2019 | cbeneat
We did figure out the issue. The plastic cover inside the LED lighting unit had a slight film covering it, which made the picture slightly hazy. We had to disassemble the LED module to get at it, cleaned it and it was fine. I didn't think this would
Electronics Forum | Fri Feb 14 12:22:57 EST 2020 | etmpalletguy
OK, you can't glue, Pallet Guys pallets are out the door, dual line reflow prevents from any lower temp solder paste.... Do you have a 3D printer? Are there parts underneath the connector in question? Measure the PCB thickness, pint out a custom hold
Electronics Forum | Wed Jun 17 18:38:21 EDT 2020 | dilogic
Blue rectangle on the screen is actual search area. Green cross points excatly to the component centroid how vision system determined it - so, your component was picked slightly off center but still within the range. Now, the reason for offset can be
Electronics Forum | Mon Sep 11 08:22:56 EDT 2023 | richardcargill
A lot of MELF components have solder ends that stand slightly proud of the main body where your vacuum would lift them, so vacuum leaks are most likely the culprit. Upping the Vacuum to the nozzle may help, but better thing would be to modify the noz