Electronics Forum | Tue Sep 18 08:14:31 EDT 2007 | jeffharley
This would not produce the condition that Darron is seeking help for as the vcd would stop due to not seeing a clinch in signal with a mechanical jam.
Electronics Forum | Wed May 27 14:20:14 EDT 2015 | travishemen
Try Dan Chretien at Southwest Automation Consultants. He has helped us with many parts. http://www.southwestautomationconsultants.com/ 928-853-2090 swuicsup@aol.com
Electronics Forum | Wed May 27 15:48:21 EDT 2015 | alpha1
Do you have a part number we probably have it. Don Burshnick Alpha 1 Technologies
Electronics Forum | Wed Oct 20 11:19:36 EDT 2004 | jax
The HSC, "Lightning Head", is offered on two platforms, Genesis and Advantis. The decision will depend on your throughput needs and price requirements. In comparison to the HSP, I would recomend the HSC. With the ability to use docking feeder carts,
Electronics Forum | Wed Oct 20 15:05:30 EDT 2004 | vickt
18"x24"), Low to high placement count, and need for Modularity tends to lead toward HSC Higher volume, High placement count, Lots of feeder capacity, established horizontal turret solution are all strengths for the 4797 HSP Of course there is overl
Electronics Forum | Fri May 26 10:59:56 EDT 2006 | James H
I have a panel with 4 boards on it. All boards have the same orientation. Is there a way to set up an offset to make the program more efficient? I also have a few panels with a couple bad boards on them. Is there a way to set up the program to reco
Electronics Forum | Wed Jul 26 11:14:50 EDT 2006 | FredC
Are these covers repacements for the tape guides? If so in retipping many thousands of cp6 nozzles we see that the window in the tape guide is often miscentered and the needle tip rubs on the same place every time it picks. I expect the miscentered g
Electronics Forum | Mon Sep 17 21:20:53 EDT 2007 | molos21
You should check your back stroke of the cutter. The backstroke is probably too long which cause a mechanical jam when you fire the cut and clinch. The anvil goes up first and then come the cut and clinch at this point the jam should appear. There is
Electronics Forum | Tue Sep 18 15:15:10 EDT 2007 | jdengler
Jeff, You assume too much. Not all VCD's had clinch in sensors. Darron did not tell us what vintage this machine is so what habsfan said could be the problem. We need more information to help. Does the machine stop when it doesn't cut the lead? D
Electronics Forum | Tue Sep 18 18:03:52 EDT 2007 | fnorradd
Thanks for all of the informations guys, after spending some time rechecking the set ups and checking for worn components in case there was something i missed, i then took some time whilst an operator ran the machine to watch. Whilst doing this i no
Focusing on the SMT field for more than 18 years, kinds of smt spare parts,like feeder ,nozzles,motors,fitlers and smt machine,juki ,panasonic ,yamaha,siemens,samsung(hanhua) ; peripheral equipment ,conveyor,AOI,spi,reflow oven
Manufacturer / Equipment Dealer / Broker / Auctions
2nd floor, West side, Building 12, Hengmingzhu Industrial Park, 32 Xiangxing Road, Shajing Tongfu Industrial Zone, Baoan District
Shenzhen, 30 China
Phone: QYSMT / MOREL USA CONTACT – SUSANTA TRIPATHY.: 1-912-373-4005 / China Contact: 86-075521635007