Electronics Forum | Tue Oct 18 07:02:47 EDT 2022 | poly
The product editor complains if I have a part that overhangs the edge of the board. Any hints on how to fix this? Set the "board" size bigger than the actual board and the use an offset to make it in the right place? Or is there a better way to say t
Electronics Forum | Thu Oct 27 13:46:36 EDT 2022 | proceng1
I concur with what Tom said. Sometimes you have to trick the machine. Without seeing your board, I can't offer any specific advice. And I am not familiar with your machine, but we run SAMSUNG machines and between those and several different MPM Pr
Electronics Forum | Wed Oct 26 22:39:01 EDT 2022 | sarason
This is not really a bug. The logic is this if you place a component beyond the edge of the board, it should falloff! So instead on having a very complex algorithm to work out component centres and then make a judgement as to whether the connector is
Electronics Forum | Fri Oct 28 13:48:30 EDT 2022 | proceng1
Well, I'm not sure about the "Trust me" button. I assume you can't tell it the part is smaller than it is because then vision won't accept it. I often add 10mm or so in X direction. In fact, when I measure the board, I just round the X up, becaus
Electronics Forum | Fri Oct 28 14:09:39 EDT 2022 | ttheis
Allowing a part to go over the board boundaries can cause collisions when boards are nested. The software on these machines has limitations but it is plenty capable and rooted in preventing physical damage to the machine. Once you are familiar with t
Electronics Forum | Sat Mar 03 12:32:26 EST 2007 | ethercom
Onsite....
Electronics Forum | Tue Nov 01 18:33:10 EDT 2022 | griinder
I assume you are programming with DPO? I am using a Fuzion, so it may be a bit different. In "Environment Settings" (The little PC icon in the DPO start bar) under the products tab I am able to change the product load options to "warning" instead of
Electronics Forum | Sun Feb 25 14:30:03 EST 2007 | ethercom
Does anybody know of a person who can train to operate and program Universal GSM machine in the Silicon Valley area?
Electronics Forum | Mon Apr 17 16:22:29 EDT 2006 | jaimebc
Are there any users currently working with Unicam and Universal HSP and GSM? If so, what offline interface are you using? USOS or UCT-52. Was there any conflict between Universal's interface and Unicam? Thanks
Electronics Forum | Mon Feb 26 07:34:18 EST 2007 | Tech
Contact smtservice@comcast.net They are one of the best and get you trained in a few days.