Electronics Forum | Wed Jul 09 14:47:39 EDT 2014 | deanm
I'm looking for a typical SMT placement defect rate from others in the field so I can judge whether or not we are in an acceptable range. If I give you a board with 200 components (0603, 0805, SOICs, 20mil MSOPs, tantalums, DPAKs and a few 20mil fin
Electronics Forum | Tue May 19 17:31:42 EDT 2009 | jamike
JUKI's the way to go, I feel getting one could be the saviour of a company if they want to run small & large batch sizes. Fairly quick setup times -after a bit of practice, reliability, very accurate placement of almost any component size. My lifes b
Electronics Forum | Tue May 26 05:28:57 EDT 2009 | grantp
Hi, So you looked at Fuji and it did not live up to the marketing? I own the latest model Fuji's and they more than live up to the marketing so I don't know what your talking about. Perfect placement, very fast, and with all 6 of our machines have n
Electronics Forum | Wed Jan 06 04:43:22 EST 2010 | deltaservices
If you are working smt machines in Europe or US then your most important issue is setup time and operators needed to run the machine. People are way more expensive then machines. I know the assembleon machines, Gem line and the new MG lines are grea
Electronics Forum | Wed Jul 16 12:13:27 EDT 2014 | deanm
Thank you for your comments so far. I believe I threw some people off by my wording. Clarification: How feasible is it to run a board straight into the reflow oven without inspecting it first for any placement defects? Is nudging parts and performin
Electronics Forum | Mon May 25 08:30:48 EDT 2009 | cyber_wolf
I assure you this is no add. I have posted on here for years, and NO we do not recieve benefit from Juki. I am just a technical guy that has worked in the trenches every day with various pick and place machines over the years. Let me re-state that I
Electronics Forum | Thu May 28 12:31:46 EDT 2009 | wrongway
We have universal advantis which us there leser machine I could'nt be happier with it we used to have Amistar machines for ten years it worked ok. but the universal lighting head works great we have had our machines for about 2 years now with very li
Electronics Forum | Fri May 29 03:27:36 EDT 2009 | grantp
Hi, I have only handled MYDATA and Fuji personally. MYDATA was not realiable, Fuji's are perfect. As for feeders the XP series, we have 5 of them, and they all use the same feeders as the older machines such as CP and IP series. The XP can even use
Electronics Forum | Tue Jun 02 22:32:09 EDT 2009 | mikehe
I can tell you from current experience that the Sony and Assembleon machines are bullet proof. I just placed 0201's on the Sony G200 and ran it at wide open throttle and it didn't skip a beat. You have to keep in mind that the speed ratings that the
Electronics Forum | Thu Jul 10 15:03:57 EDT 2014 | alexeis
Hi, An answer to this question is very complex. The amount of components and their type is only one parameter to determine the level of failure. Additional parameters that can influence are: 1. The density components on the card 2. Machine type and
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694
