Electronics Forum | Wed Sep 08 11:30:49 EDT 2021 | kumarb
We can vouch that UTSOURCE was excellent in assisting in the repair of some obscure farm equipment for a local farmer. Their Hitachi (original) LCD display driver was blown on a number of PCBs but was able to source the replacements through this port
Electronics Forum | Tue Aug 24 20:24:30 EDT 2021 | cbeneat
We have X5's. You are able to turn inspection on/off on the screen. Obviously an older machine running XP. I have never had a bad experience with ASYS support. I usually call our regional Field service rep. Where are you located?
Electronics Forum | Wed Oct 06 20:23:38 EDT 2021 | stephendo
If you can, it would be best to have a scrap board with a scrap BGA and drill a small hole in the bottom of the PCB and attach the thermocouple lead to a ball. This is assuming that you have a convection oven. If you have an IR oven, and that is wh
Electronics Forum | Tue Oct 26 20:02:48 EDT 2021 | astarotf
Yes Deni, we just found the battery on the EPC-5A board. I was wrong, because of my ignorance. We have the EPC-5A board, this one allows us to have a larger capacity disk, currently we have a 1705 MB seagate I hope after mounting this battery to be
Electronics Forum | Tue Nov 09 13:30:55 EST 2021 | dontfeedphils
It's possible to emulate USB software keys, but it's obviously frowned upon legally. It would also be a chore finding one to emulate and get working, if at all possible. You're not able to purchase a new key from Hakko? Obviously they aren't going
Electronics Forum | Tue Dec 21 17:15:49 EST 2021 | vtdivtecs
yeap I was able to figure it out and avoid my head being on a stick anywhere. if you log out of tpsys and into hw config you can turn off the hydra head there, then unplug the hardware and the machine will run. if you just disable it inside tpsys t
Electronics Forum | Wed Apr 20 02:04:07 EDT 2022 | sn
@charliem, For the clean process board using "water-soluble" fluxes, we will send the board to aqueous wash with DI water first if not able to manage to proceed with the second process within 24hours. Then, keep the board under room temper
Electronics Forum | Mon Jul 11 18:02:27 EDT 2022 | tey422
Yes, just tabs not full perimeter. Can you please fill me in more detail since I am not too familiar to router bit types? I am looking for the right size bit that would be able to install to the Sayaka machine without much trouble just like diamond
Electronics Forum | Tue Jul 19 01:53:53 EDT 2022 | ttheis
We are in process of calibrating one of our GSM machines; we were able to successfully calibrate the front and rear ULC's but when we moved on to calibrate the head we get a spindle runout error midway through the routine (pic attached.) The spindles
Electronics Forum | Fri Dec 02 19:19:21 EST 2022 | zsoden
Hi, I've picked up a used Yamaha YG100 but it was without any manuals. I do have a YG88 user manual for reference but it would be preferable to have the YG100 manuals too. Is anybody able to provide a copy? I'd also love to get my hands on service