Electronics Forum | Mon May 16 17:05:17 EDT 2005 | pde
Also concider if you will be going lead free in the future as conversion can be a added expense. You may think about learning and going lead free from the begnining as the indestry is rapidly moving in this direction.
Electronics Forum | Mon May 16 17:23:28 EDT 2005 | alandra516
Fred, call me I may be able to shed some light on what to look for. Glenn 903-892-5636
Electronics Forum | Wed May 18 19:12:26 EDT 2005 | HOSS
Hello, Assuming that your dwell and coverage at the wave are in order..... Have you checked the angle and pressure of your fluxer air knife? You can only count on capilary action to a point. The air knife, set correctly, will help get your flux t
Electronics Forum | Thu May 19 12:50:19 EDT 2005 | splice1
Hi Hoss, Thanks for your reply. Yes I am seeing the flux flood over to the top surface of my board, so to an extent I am not concerned with the fluxer. I believ that the foam fluxer is functioning adequately.
Electronics Forum | Fri May 20 08:15:21 EDT 2005 | davef
better" doesn't make sense. Additionally with no preheat, primary side components see a large delta T when they hit the wave.
Electronics Forum | Thu Jun 02 08:27:08 EDT 2005 | klukens
I agree with Steven. I have been involved with AOI for over 18 years. I was first introduced to it when I worked for Solectron. The AOI machines back then were more or less used as a selling item and very cumbersome to use. I have used and or operate
Electronics Forum | Wed Jun 08 04:08:35 EDT 2005 | SB
Lupo, Omron AOI systems are definitely the best and most accurate, with the exception of there desktop system which is poor in comparison. They used to be very expensive , but I believe their new models are well priced. If you want solder joint ins
Electronics Forum | Thu Jun 16 08:41:45 EDT 2005 | ghenning
Hi Fred, Were you able to develop enough confidence with the AOI to eliminate manual visual inspections and save money/time? How did you manage this and still get good solder joint quality? Thanks, George
Electronics Forum | Fri May 20 10:11:50 EDT 2005 | davef
Emerson Ventilation Products 10048 Industrial Boulevard Lenexa, KS 66215-1219 Phone: 913-752-6000 Fax: 913-752-6478 http://www.emersonvent.com
Electronics Forum | Sat May 21 07:51:08 EDT 2005 | jdengler
We would need more info to answer. How many boards get run between de-drossings? How many days between de-drossings? Are you removing dross only or some good solder with it? Jerry