Electronics Forum | Fri Oct 28 13:58:57 EDT 2016 | ttheis
Hi everyone, We just picked up an old VIP70 oven and it is in need of more maintenance than we were told when we bought it so I'm working on a few issues. The main thing right now is linking the FCU controller to the PC. I've tried using both seria
Electronics Forum | Thu Jun 08 18:40:44 EDT 2017 | simons
We have a Samsung that we have replaced all the amps and are still getting the Z axis motor alarm failure. On the “Position Window” before and after we try to “Home” the machine, the values for “Z-Axis” for all three heads prior to the “Home” action
Electronics Forum | Thu Jun 08 22:54:57 EDT 2017 | palsrvs
Hoping to get help on our Samsung CP40. We are trying figure out what part to replace for a Z height motor alarm detected Error Code 1523. Originally Head 1 was having this error. Swapped out I/O board and Z-Axis control for head one and same error s
Electronics Forum | Wed Sep 05 06:34:08 EDT 2018 | oriolsancheza
Hi Rob, Thanks for your fast response. In fact, after a better look to driver boards, it has leaking SMD Electrolityc caps. Unfortunately after replacing them in 3 units, one of them gives 90% of times, ALARM4 led ON. Looks like a comunication pro
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Mon Aug 07 18:00:35 EDT 2000 | Keith
Hi, I'm looking for a kit or design for a high temperature measuring device (thermometer). The necessary feature would include: measures air temp. senses up to 700 degrees c audible alarm max temp memeory setting Any help would be greatly appr
Electronics Forum | Fri Jul 07 13:39:53 EDT 2000 | pr
I know you're not gonna buy this one... But we had the same thing and it was the metal sleeve covering the ball screw. Spray some Biral on it to loosen it up. I didn't believe it but we did it and instantly the problem went away (2 times on 2 differe
Electronics Forum | Tue Jun 01 19:35:39 EDT 2004 | Ken
There are studies out there that looked at gold embrittlement. The overall consensus is to not exceed 5% by weight. As far as the conductivity question, as themo/mechanical creep fatigue sets in, your conductivity will be affected as the joint is s
Electronics Forum | Fri Aug 20 12:06:53 EDT 2004 | danhui888
Pls contact ECD for built in monitoring system or KIC 24/7. This products will monitor your oven performance and profile round the clock without stopping. If your profile is out of the spec, the software will gives you an alarm and the machine will s
Electronics Forum | Fri Aug 20 12:06:55 EDT 2004 | danhui888
Pls contact ECD for built in monitoring system or KIC 24/7. This products will monitor your oven performance and profile round the clock without stopping. If your profile is out of the spec, the software will gives you an alarm and the machine will s