Electronics Forum | Thu Sep 16 09:29:21 EDT 2010 | san_1023
Weller and Hakko have some good soldering > stations, hot air SMD rework system and BGA > rework systems: _a class=roll > href="http://www.wellersoldering.blogspot.com/" > target="_blank"_http://www.wellersoldering.blogspo > t.com/ _/a_ I am t
Electronics Forum | Thu Nov 10 09:25:54 EST 2011 | kevinemslie
We have had an issue where a turnkey company has a solderability issue with boards that we supplied. The most thorough way of proving thay the boards work in my opinion is to take a bare panel randomly from the batch (same date code) to have it paste
Electronics Forum | Mon Jan 28 13:13:19 EST 2013 | chifutbol
I am just being introduced to GemLine and Assembleon. I have been trying to get the programs on two other computers so we get more work done. One is windows 7, the other is vista. I was unable to get PCP explorer or editor installed on the windows
Electronics Forum | Thu Feb 21 09:53:00 EST 2013 | Mr_Bo_Jangles
Has anyone used their AOI to try to catch components that may be inadvertently placed in a location it shouldn't be? Every once in a while our equipment may drop a part onto a PCB and that part will adhere to pad. So the question has been brought u
Electronics Forum | Thu Feb 06 12:32:24 EST 2014 | gnus
Hi all, During our last production run, our MyData TP9 machine shut down on its own mid assembly. Screen went blank. I turned off the power switch and waited 10mins before trying to power it up again. I turn the switch on and hear the fan turning on
Electronics Forum | Sat Jun 11 03:27:30 EDT 2016 | muzzy
Hello. We have a problem with our Juki 740 machine. It does not start at all, both monitors are blank. The only error we can see is "FAIL" LED on CPU board and red "LD2" LED on "AC SERVO BOARD". Does anyone know what the "LD2" LED means? Or, even be
Electronics Forum | Tue Dec 01 15:32:27 EST 2020 | spoiltforchoice
Could be your graphics card driver is set to output a resolution/refresh rate not supported by either monitor you tried. In that case XPs "Safe Mode" should use safe defaults just like it is doing when you see the loading bar. Another option is someh
Electronics Forum | Tue Dec 01 20:50:51 EST 2020 | tueftler
Hi there. Thank you for your reply. I have tested the VGA signal with two different VGA to VGA & HDMI converters without success. Now i have connect my oscilloscope onto the signal. RGB,V and Hsync...no signal at all after WinXP boot cycle. If i
Electronics Forum | Wed Dec 02 10:00:17 EST 2020 | spoiltforchoice
That STOP error code does google. It would suggest an incomplete or corrupted windows installation. if safe mode doesn't work its very unlikely normal mode is. Sadly fixing XP issues is much harder than it is these days with Win10 which has repair fu
Electronics Forum | Tue Oct 26 17:30:36 EDT 2021 | dilogic
Messages indicate bad battery on EPC-5 CPU board, not SYS68K CPU-30. You have to fix that first. What kind of hard disk is installed? EPC-5 boards support small disk sizes, so sometimes , if larger disk is used, users "trim" reported capacity to lowe
