Electronics Forum | Wed Jun 21 14:33:57 EDT 2023 | glr
You should a sequence that a D=2 Q=3 and X in going to be your bin location.
Electronics Forum | Wed Jun 28 12:04:28 EDT 2023 | nickadams
Thank you for your input. Do you know what might have caused this to happen? Just trying to prevent it from happening next time.
Electronics Forum | Tue Nov 18 09:54:49 EST 2014 | gregp
Hi Adam, Good question. I know I am seeking a lot of details. Here's the deal. Five years ago I acquired the assets of Contact Systems. Since then I have been re-manufacturing the CS-400E machine which if you are not familiar with is a light guid
Electronics Forum | Thu Feb 05 14:33:32 EST 2004 | paul_bmc
I am in the process of programming my first PCB on the CS-400E machine and am having problems. I am too impatient to wait for the manuals on order so I thought I might see if someone out there might have some suggestions. I have done some research o
Electronics Forum | Fri Feb 26 14:36:58 EST 2010 | gregp
Hi Dave, The short answer is "it doesn't". The mascot is simply a light guided assembly system. The major difference is the CS-400E machine has the fully programmable cut and clinch unit doing it's thing under the board while it is being assembled.
Electronics Forum | Wed May 16 12:53:26 EDT 2012 | deanm
CS-400C: As with anything, once you are up on the learning curve its really not that bad. The "E" machines should be easier due to the touchscreen and the floppies are PC compatible unlike the "C" and "D". There are third party software providers tha
Electronics Forum | Mon Jun 02 14:53:52 EDT 2003 | scottefiske
We are currently looking at a CS-400D component > locator with automatic cut & clinch from contax > ltd .Anyone who has had good or bad experiences > with this type of equipment and are prepared to > share,it would be much appreciated. Are you b
Electronics Forum | Wed Mar 10 11:19:59 EST 2004 | mrmaint
Paul, I have seen harness issues in the past that have given some unusual results. The problem we found was that depending on the rotation and position of the cut/clinch unit the opens/shorts were not consistent. The first place i would look is at th
Electronics Forum | Tue Feb 26 15:20:12 EST 2008 | schorschimi
The german machines use the same basic procedure as the Compact Systems CS-400E but (to my knowledge) no cut and clinch. Can you give any information about manual visual inspection after stuffing boards with such machine. If stuffing boards without
Electronics Forum | Thu May 07 23:02:35 EDT 2009 | cusackmusic
Bob has been very helpful so far. He was very reasonable on the price for the manual too. I think I'll have this thing in production by Monday Morning! So far I've replaced the 5V Power Supply, re-aligned the X and Y, and re-laminated the table to
