Electronics Forum | Fri Jan 03 00:22:02 EST 2003 | Steve
We have an Ekra E5 that uses what looks like standard auto valve stems to dispense the cleaning fluid. They leak.. Are they just standard schrader valves or are special to withstand the chemistry of stencil cleaner?
Electronics Forum | Fri Feb 21 16:03:00 EST 2003 | pjc
Is anyone out there dispensing no-lead paste with a machine? If so, please give me some feedback- do you see any difference in performance vs. lead content paste? What type of valve/pump are you using. Thx in advance.
Electronics Forum | Thu Jun 26 07:20:09 EDT 2003 | emeto
Hello, What are the ways of placing underfill material under the flip chip.I read about dispensing from one side and dispensing from 2 sides. There must be other ways and I suppose some of you know them.I will appreciate any knowledge on the subject
Electronics Forum | Tue Aug 05 08:33:06 EDT 2003 | Mike Stadt
Is jet dispensing of highly filled polymers possible? I have only seen applications with SMT adhesives, where the filler content is on the order of 10%.
Electronics Forum | Wed May 26 01:24:58 EDT 2004 | Adam
Hi Can anyone tell on how to go about creating an SPC chart for monitoring and measuring dispensed glue dots ? Thanks Adam
Electronics Forum | Sun Jul 25 21:00:27 EDT 2004 | Eric
Thanks for the info. I have already talked with the guys from SIP (Speedline) for the inquiry about Camalot Dispenser. But I'm looking for other machines to benchmark so at least there would be a comparison.
Electronics Forum | Sun Aug 01 11:27:40 EDT 2004 | haran
What is the best epoxy attachment method for Heat Sink?The operator always miss the solvent dispensing application prior to epoxy dispense which cause the heatsink falling off at customer site as well as in the factory?Any advise?
Electronics Forum | Thu Sep 01 10:52:22 EDT 2005 | clampron
Good Day Everyone, Is anyone using a glue jet for dispensing epoxy? I am looking at different application methods and this seems to eliminate most of the problems with needle application. Any input would be greatly appreciated. Thanks In Advance C
Electronics Forum | Thu Oct 20 00:46:43 EDT 2005 | bigvern
Hi can anyone advise as to wether the Camalot Gemini 1 dispenser is capable of doing lines and circles as well as the high speed dots. The facility appears to be there in the software, just wondered whether anyone had tried.
Electronics Forum | Wed Nov 23 12:23:24 EST 2005 | jdengler
-Cartridges will fit an auto dispenser on the screen printer or a hand dispenser. Will waste some paste at the bottom of the cartridge. -Jars will be a little harder to deal with. They are messy. Can get all but the last couple of grams of the pas
A Manufacturer of High Quality, Precision, Automated Fluid Dispensing and Conformal Coating Systems, SMT Cover Tape Peel Tester and Lead Forming machines for through-hole component preparation.
611 Hollingsworth Street
Grand Junction, CO USA
Phone: (970) 245-0408