Electronics Forum | Tue Dec 19 12:01:29 EST 2006 | patrickbruneel
Here�s a link to a previous thread that might be helpful http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=6947&#Top Look what KEN has to say on the subject Patrick
Electronics Forum | Wed Feb 20 12:22:39 EST 2008 | shrek
KRIKIES, a designer insisting on cleaning no-clean residues! the BLAME-THE-PROCESS bandwagon travels everywhere, me lad!
Electronics Forum | Tue Jun 02 21:13:08 EDT 2009 | kircchoffs
thanks for the inputs. we are planning to run on fuji nxt i think cycle time will not be an issue. i still have another question if we can still use the same reflow profile for paste? or do we need to create another profile?
Electronics Forum | Thu Aug 20 07:10:46 EDT 2009 | davef
Questions are: * On what portion of the second side of the board [eg, solder only, solder mask only, etc] do you see this white hazy residue? * Could you attach a picture? * You mention cleaning this residue. What have you used to clean the residue?
Electronics Forum | Thu Aug 20 08:24:07 EDT 2009 | padawanlinuxero
Hi ! In both solder mask and solder joint, I am going to upload a picture today promise, I use only IPA and a ESD brush this kinda clean the problem
Electronics Forum | Wed Apr 28 14:52:03 EDT 2010 | davef
When we hear the words 'flexible circuit' and 'delamination' in the same sentence, we think: * Excessive reflow temperature. * Entrapped moisture. Boardhouse: I hope this is a step towards redemption.
Electronics Forum | Mon Apr 05 08:25:31 EDT 1999 | ADRIANO FERNANDES
I require some feed back from any one who knows about using a voc free flux in a nitrogen wave solder machine soldering both through hle and smt componants. What disadvantages are there when using this flux? Do you have any contact
Electronics Forum | Wed Oct 07 22:40:05 EDT 1998 | Eric R.
Came a cross an interseting observation/question. I'll need to filter additional information and specifics to those whom may be able to assist me. But for now; I use a water soluble base organic flux manufactured by Kester (the exact solution will
Electronics Forum | Sun Dec 11 22:39:36 EST 2016 | ppcbs
We have been using the Amtech line for over 12 years now with all of our PCB and BGA Rework. The NWS-4400 is mildly active and will give better results with Lead Free Solder. Note that the LF-4300 is considered a No-Clean. However it will show lea
Electronics Forum | Wed Nov 12 10:45:12 EST 2003 | johnthor
Absolutely, read the manufacturers MSDS. You do have it, don't you? We use Kester 971 and it reads Waste Disposal Methods: According to local regulations. Considered biodegradable. We did take the precaution of informing the local authorities and
Flux is your source for custom cable assembly, wire harness, and electrical enclosure manufacturing. We design and manufacture to your specification and can assist with connector selection, layout, and manufacturing techniques.
Contract Manufacturer / Assembly / Soldering / Test Services / Turnkey
4030 8 Street SE
Calgary, AB Canada
Phone: 1-800-557-3589
