Electronics Forum | Mon Dec 20 21:16:30 EST 2004 | adlsmt
DeHart went out of business some time ago. I do not know if someone bought the rights to sell spares but I do have a DeHart printer in storage that perhaps can be canabalized for the parts you need. I got it at an auction but it has some type of sens
Electronics Forum | Tue Mar 28 19:34:50 EST 2006 | daxman
Hey Sr.Tech .. Thanks for you help with my CP6 problems by the way.. Did you just get this machine? We've had many initial problems with ours. Most of them were related to the air pressure settings. There should be 2 regulators on the back of the
Electronics Forum | Thu Feb 22 18:28:28 EST 2007 | Cmiller
You could probably put a 1/4" plate of steel over the aluminum and make some shorter magnet pins. I think the factory upgrade was $3500 to $4500. Its hard to justify the cost based on saving maybe 5 minutes a set-up for an operator. But your lines wi
Electronics Forum | Mon Jun 18 10:11:52 EDT 2007 | dyoungquist
Almost every board/panel we build is double sided and we use an MPM SPM screen printer with no problems. The screen printer is not the cause. We have seen heavier parts fall off the first side when going through the reflow for the second side. We
Electronics Forum | Fri Jun 27 18:43:29 EDT 2008 | 1036
Hi Chris, Nice to talk to you. Below is the link which you can follow to download the pictures showing the system booting procedure. Thanks for help. http://www.filedropper.com/mpmspm Best Reards, Jack Xu Gi Circuits, Inc. 10850 S. Wilcrest D
Electronics Forum | Sat Jun 28 07:29:36 EDT 2008 | proy
Chris I got both my SPMs running. The one with the touch screen; I think the touch sensor is worn out, 1 in 10 trys we can select the MAINTENANCE menu and run RESET properly, other areas always select fine. Your problem sounds like it is missing
Electronics Forum | Tue Aug 10 09:42:33 EDT 2010 | kevslatvin
We are using the Red-E-Set supports from Production solutions in our Opal P&P machines and MPM SPM printer. Ours are the manual system though, they do have an automatic system. With theirs once you set them at the setup of the job you don't have to t
Electronics Forum | Fri Feb 08 15:00:05 EST 2019 | mattkehoe
We are very close to having the printer up and running but have hit a snag that we hope someone has seen and can offer a work around. The machine does not have the auto stencil wiper attachment parts in it. Did not matter before the hard drive crash
Electronics Forum | Wed Dec 29 19:05:46 EST 2021 | cyber_wolf
Try deleting a couple print programs.
Electronics Forum | Mon Jan 03 00:36:19 EST 2022 | hello112
May be caused by poisoning or illegal shutdown, restore the system
