Electronics Forum | Mon Apr 08 17:27:36 EDT 2024 | kingkelvin
I found a 0.9mm hex tool - but if I adjust the indicators "all the way up" on the shaft I get all current ranges at 255 (so obviously too high on the shaft) but if I place it anywhere else on the shaft (slightly down from top, or all the way down as
Electronics Forum | Mon Apr 08 15:39:10 EDT 2024 | mistrthou
The error is: MOT-Command/205: Motor speed out of control Motor speed deviates from expected speed. – Problem with power supply, motor current too low. – Mechanical problem, friction too high or tool stuck in Z. I'd be looking at excessive friction
Electronics Forum | Tue Apr 02 14:56:30 EDT 2024 | kingkelvin
Hi all - my problem is a bit worse now - I can get all hydra tests to pass in extended service, except indicator levels at current 7 a bit high past 190 limit at ~210-220 - other than that hydra bank re-installs OK - but still it makes a bad hitting
Electronics Forum | Mon May 06 11:24:04 EDT 2013 | amelby
Hi, Thanks for the help, The software on the Mydata is at least 2.9 I just had it upgraded last year. Arnie
Electronics Forum | Thu Jun 25 12:11:03 EDT 2015 | island2013
Let us know how it goes. We offer Mydata support and parts should you need it. http://www.islandsmt.com
Electronics Forum | Tue May 07 09:20:43 EDT 2013 | dontfeedphils
That may have fixed it, but it doesn't sound like that would be the original cause.
Electronics Forum | Thu Dec 21 17:04:28 EST 2023 | cyber_wolf
Disable the hydra head.
Electronics Forum | Sat May 04 14:36:53 EDT 2013 | dontfeedphils
It's been a while since I've used a MyData but I believe what happens is on the bottom of the hydra black metal piece is a mark that the vision system uses to locate the tools as they pass over to center the parts. Something may have happened to this
Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
Electronics Forum | Tue Apr 23 02:43:41 EDT 2019 | bukas
hello everyone, my ERSA has some sort of RAM error, error messages and suspected IC in pictures. did any of you come across something like this and does anyone know where/how to get new IC/motherboard? Thank you.