Electronics Forum | Wed May 09 12:07:52 EDT 2001 | caldon
My personal favorite is the Siemens F series and the UIC GSM platform. Both Siemens and UIC have awesome resources for csp, flipchip and baredie processing - Siemens= Dan Baldwin from GaTech; UIC = George Westby from UIC labs. My second choice would
Electronics Forum | Mon Mar 11 13:46:14 EDT 2013 | ngineer
Michelle, I've tried this, and the extra information goes away, until you save and then access the pick and place data again, then it is back.
Electronics Forum | Sat Mar 09 02:25:35 EST 2013 | ngineer
I'm setting up a rather complicated job on our quad IVc. I was almost done (after days), and after i did the sequence, i saved it, downloaded it, and started checking the picks and places, well, i needed to change one, and went back to the sequence,
Electronics Forum | Mon Mar 11 13:27:56 EDT 2013 | ngineer
Bobpan, I have found the same, although this issue is different. If go to one of those lines in CC, and delete it, then replace it with a pick 9, then save it, i go back to the pick table, and it shows the same lead inspection electrical test, et
Electronics Forum | Tue Mar 12 07:46:26 EDT 2013 | ngineer
bobpan, It only happens with this program. CC ver 7.54, IVC V 3.05 If i leave CC out of it, and edit the sequence using the HHT, it sticks. but if i download from the assembler to CC, it's messed up. if i then fix it in CC, the minute i save
Electronics Forum | Tue Oct 30 12:20:58 EDT 2007 | adlsmt
You may want to clarify how much $$$ you have. If you look at a quad 4C call PPM, I believe they have a windows based operating system now. I think a 4C with some feeders would cost you $5K to $20K depending on condition and feeders. I believe you wa
Electronics Forum | Wed Oct 24 11:06:08 EDT 2007 | slthomas
While many here would probably shoot themselves at the thought, I'd recommend a Quad IVc. You can't get much smaller, they're easy to set up, easy to operate, and for the most part run pretty much forever with minimal maintenance because they're so m
Electronics Forum | Fri Nov 05 11:30:53 EDT 2010 | deanm
We have a Quad QSV-1 pick and place machine that has performed fine for us with the exception of cylindrical glass (MELF) type diodes. The machine often fails to pick these out of the tape to the point where it is easier to hand place them. As far
Electronics Forum | Tue Mar 13 12:15:14 EST 2001 | onset
We have a 4C and it places 0402 components without any problems. The tricky part is getting the machine to pick them up out of the feeder it takes patience but you will get it. jake p.s. you
Electronics Forum | Thu Jun 03 20:15:23 EDT 2004 | Ken
My Machine guy was a 4 year ex-quad Service Engineer. Prior to that he spent 6 years in a CM programming and servicing quads from QX toQ3c/4c q100 series. These are opinions. Nothing more. I have noticed that the smallest players in the market
WINTECH provides new/used/pre-owned SMT, AI & PCB Assembly (PCBA) equipment of various brands. Also supply service, modification & original or local-made spare parts. We are also an appointed agent for well-known brands.
Equipment Dealer / Broker / Auctions
NO. 1 LORONG SAGA JAYA 6
PERAI, 09 Malaysia
Phone: 6043809899
