Electronics Forum | Tue Sep 12 12:43:26 EDT 2017 | deanm
50) traces. The design will be tested for safety and a file will be created listing all the critical components such as transformers, relays, wiring, enclosure material, etc. On the manufacturing side, a manufacturing facility must be indicated in
Electronics Forum | Wed May 19 20:11:21 EDT 2021 | compit
I have two machines - Emerald-X and Topaz-X. I cleaned (and changed Koganei electromagnets) only in Topaz-X - Emerald-X is in very good condition :) But my Emerald-X have SF (not FNC) heads. If head 1 is OK - change the relays with head 2 and check.
Electronics Forum | Wed Sep 27 10:45:16 EDT 2000 | Chris May
Donna, We have a Contact 3AV system. Not exactly the same, but probably close enough to sort ou your problems. Send an e-mail to aaronw@pearpoint.co.uk and relay your troubles. If anyone (here) can help, he can. Regards, Chris May.
Electronics Forum | Thu Jul 06 17:05:49 EDT 2000 | lucky
The best thing to do is to call Fuji America in Chicago (847.821.2401); they will have the correct information. However, before you call determine your needs and then relay them to Fuji. You do not want to invest a lot of money and only utilize it (
Electronics Forum | Wed Jul 01 07:31:27 EDT 1998 | Sherry
| Looking to contact some users of Vitronics reflow ovens. | Which model do you use? | Overall opinion of equipment and company? | Thanks in advance I've been using the Vitronic's SMD-722/32 Series. It's been in operation for 11 years and the only
Electronics Forum | Mon Jan 07 10:56:40 EST 2002 | bcaler
Who did you buy this oven from? What is the model number? I bought a used Conceptronic oven last year...It ran great when I saw the demo. But, when is arrived at our factory we found someone pulled out some relays and it wouldn't heat. Hope you h
Electronics Forum | Thu Apr 25 23:13:24 EDT 2002 | ianchan
Hi Dave, Bbbaaa....*note the sheep eyes*....bbaaa.... ok, that was a great wakep up rap! I'll relay that strongly worded paragraph to the calibration in-charge, see what he has to say for himself? thing is, such situations reflects on us as a whole
Electronics Forum | Wed Jan 07 12:18:37 EST 2004 | teamcanada
Standard boot sequence doesnt support proper power for vision. We boot up without power to camera amplifiers, turn on amplifiers post power up and vision is OK but Emergency Stop with Error Codes 9152 and 9154 pop up during production. Possible flaky
Electronics Forum | Wed Aug 04 23:12:37 EDT 2004 | dougt
To get you started: You would begin with a comparitor, one input would be referenced to a voltage that you want the output to "trip" at. The second input would be where you apply your "voltage" that you are using to start the motor. The output of
Electronics Forum | Tue Dec 13 09:15:56 EST 2005 | Samir Nagaheenanajar
5% Bi results in less plasticity * Formation of low temperature (ternerary phases) not detected. I don't advocate the use of Bismuth, per se, but rather I'm just relaying info. that I learned this from a Lead-Free seminar that I attended at Riyadh