Electronics Forum | Thu May 18 23:36:46 EDT 2017 | neoply
Hello all. Thanks for taking up your time to read my post. In this age of questing for ever-more-efficient circuit designs, I have been presented with an anachronistic design problem: I need to keep a roughly constant load on a steam-powered turbine
Electronics Forum | Fri Jun 19 15:03:15 EDT 2020 | jmelson
OK, I am really happy with the robustness of my CSM84. I wonder how hard it would be to hack up one of these 3-phase machines to run off single-phase power? Mostly, it just feeds a big DC supply for the X-Y servos. 2 heads with ANE should be just FI
Electronics Forum | Thu May 24 13:14:59 EDT 2007 | mfgengr
The answer is simple...kind of. The short answer in terms of total cost (if you don't run an air conditioner) is there is no difference. The technical answer is: The First Law of Thermodynamics - Conservation of Energy applies. You have an entire s
Electronics Forum | Fri Oct 28 04:56:12 EDT 2016 | lilybell
I read a few posts here about resistor in led applications. The thing is, the resistor has clarified as this shows:was always use with a power source delivering a higher forward voltage than the led could tolerate(ex: a 9volt battery hook up to a 3w
Electronics Forum | Fri Sep 25 06:39:15 EDT 1998 | Wayne Bracy
| Does anyone know where I can get conductive benchtops? NOTE: I don't want a mat and I'm already using (and unhappy with) a laminate surface glued to a wooden table. Any and all info would be very much appreciated. | BTW: I'm also looking for conduc
Electronics Forum | Wed Jan 21 10:27:27 EST 2009 | gidster
Ok. As you know the machines changed a bit after > 95 due to CE regulations. > > There are no drawing > on board/box level in Panasert > machines. > > However normaly i`ts the 100 volts > thats "shorting out" the machine and shuts it > down. C
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Tue Nov 22 09:38:12 EST 2011 | daxman
Good morning everyone, We're whipping our maintenance into shape. For starters, we've acquired the proper lubricants for our Fuji machines. Most of the lubricants (AFC, LRL-3, Daphne EP2) come in accordion/bellows style grease tubes. This isn't a p
Electronics Forum | Fri Sep 07 04:25:52 EDT 2012 | grahamcooper22
As soon as the oven temp falls below 40 C and the RH rises above 5% then you need to consider that the floor clock will start. Long term storage of devices in an oven is not good for them as it reduced their solderability and can affect their perform
