Electronics Forum | Tue Mar 04 10:50:25 EST 2003 | ggspook
Hi Mike Interested on your thoughts about (Pam) Placement Accuracy Measurement I am looking into establishing Accurate repeatability of my equipment we check our calibrations Regular and the calibrations are in spec but this does not guarantee
Electronics Forum | Wed Dec 17 08:49:04 EST 2003 | patrickbruneel
Kev, It looks like you have a preheating powerplant and you still only get the board up to 85 Deg. This indicates that the preheating is out of calibration or the range settings might be very wide (Fex the preheat elements shut down at 500 and go ba
Electronics Forum | Sat Feb 14 12:25:37 EST 2004 | I ramos
I populate several thin panels (0.032")using a > Samsung S-2000 P-N-P machine. With panel sizes > of 8" by 10", it is very difficult to clamp the > panels into the machine with deflection and > bowing. Also, the Samsung makes it very difficult
Electronics Forum | Sat Jul 24 09:06:40 EDT 2004 | davef
We believe that many manufacturers' recommended pads should be close to the last resort. Recommendations are: * Standardize with the IPC guidelines or those by Jim Blankenhorn [ smtplus.com ]. Anyone that wants to change from that standard needs to
Electronics Forum | Fri May 27 14:24:18 EDT 2005 | james
We are currently having problems with our SPM AV Screen printer. It is an intermitant problem, sometimes it will make a loud noise as the stencil is going down on top of the board and sometimes it does not meet its destination. Sometimes the machi
Electronics Forum | Tue Oct 11 18:35:59 EDT 2005 | stepheniii
How big a tank do you have at the compressor? Basically the bigger the better. You will still have the same duty cycle ratio but the compressor won't be cycling as fast. Hopefully someone here knows what a good size would be. And when you say "kic
Electronics Forum | Wed Oct 12 07:47:42 EDT 2005 | Comp tech.
Sean, I just installed a whole new comp room in our facility. 1, By kick off do you mean the comp goes into an idle mode,or shut down completely? If it just goes into an idle mode, this may be caused by your supply manifold being to small in diameter
Electronics Forum | Thu Dec 08 11:50:40 EST 2005 | Stefan
If you mention mis-alignment and missing component in the same sentance, I suspect the component is not properly released after placement. Assuming the Juki machines use an air blow, after vacuum shut off, than I would look at a correct air flow firs
Electronics Forum | Tue Mar 14 14:25:15 EST 2006 | geb
Hi, I have a 1995 Universal GSM which won't zero its axis, so can't run. It crashed last night after displaying a "swapper.dat" file being full. I have restarted and checked the available space on the hard-drive - it has over 50% freespace. After st
Electronics Forum | Wed Apr 26 13:42:15 EDT 2006 | pfifla1
I sold a person a fuji assembly machine, he wanted in with the package the copy of flexa that the people who originally owned the machine had (this is not pirated or anything like that) i had the person who owned the machine and purchased the flexa t
.gif)
