Electronics Forum | Fri Sep 14 15:31:02 EDT 2001 | davef
How in earthly heaven would someone else have a report analyzing the defects on your boards? Among the good failure analysis labs that can assess situations like yours are: * Robisan Laboratory 6502 East 21 St Indianapolis, IN 46219 317-353-6249 fax
Electronics Forum | Mon Nov 13 02:37:36 EST 2017 | slah6678
Recently we facing the Golden finger reject due to contamination with solder after the reflow. Any solution for this kind of reject ?
Electronics Forum | Sun Jun 12 09:29:41 EDT 2016 | davef
I'd guess that the interconnect pads on the BGA have poor solderability. Confirm this with testing at an independent lab. Work with your supplier to resolve the issue.
Electronics Forum | Mon Sep 17 02:56:40 EDT 2001 | mugen
Hi, (me been absent for some time...) Are your brds confirmed HAL over copper? (check out what Dave F mentioned abt possible root causes) or are the brds HAL over nickle? (shd be no problem here, if so?) or are the brds strictly nickle plated pads?
Electronics Forum | Wed Jan 04 07:32:35 EST 2017 | pavel_murtishev
Good day, Having recieved new batch of PCBs with OSP surface finish, I have noticed that some polygons not covered by solder mask and solder paste become darker after second reflow cycle compared to PCBs not being sent to reflow. I wonder whether i
Electronics Forum | Sat Jun 11 03:26:20 EDT 2016 | nagesh
Hi, I have problem with one of the BGA Top Cap Detached from the Solder Balis attached to the BGA. Advice /Suggest why the Top Cap Has come out. We produced 4150 Pieces & had similar problems with 5 Pieces. Thx in advance for all your suggestions. T
Electronics Forum | Thu Jan 13 17:46:04 EST 2011 | davef
We've never seen the defect that you describe, but in wave soldering-land blowholes usually are caused by moisture in the board that out-gasses through the too thin plating of through holes. * Bandaid fix: bake the boards * Long-term fix: Obtain boar
Electronics Forum | Tue Nov 07 21:49:05 EST 2000 | Dave F
Cheers to you Your gold plating is specified for the gold wire bonding between the die of your BGA and the pads on the BGA substrate. For solderable surfaces this is heavy on gold for use on pads. Gold SB thinner on pads to limit the amount of gol
Electronics Forum | Thu Jul 05 21:07:09 EDT 2012 | davef
Probably they had a problem with a certain product, tried baking, the problem went away and ever since there stuck with this money loosing process. So, ... * Write up a plan to split a couple of batches, bake a portion of each batch, don't bake the o
Electronics Forum | Thu Oct 24 03:03:13 EDT 2002 | harriss
Hi: The component height will increase on the PCB after reflow soldering. But i don't know the accurate data of the increased height. Who can help me to get it? The stencil thickness is 5 mil we used. Thanks Harriss