Electronics Forum | Thu Oct 16 14:12:36 EDT 2008 | evtimov
Hi, I think the standard was IPC 6850. But I will recommend to go directly with the sigma test. Place parts with the machine and measure the placement accuracy on another machine. 4-5sigma at 50um should be a good machine. If they have sigma in thei
Electronics Forum | Thu Sep 26 10:04:46 EDT 2013 | nophsem
I tested original 'bad' SRX card in the other machine and it doesn't work, same error: SRX Autobaud Motor error #5 With our QUAD 4C, (Machine speed setting) MC 53= 0 (high speed), I changed =1 (low speed), same error
Electronics Forum | Wed Jul 03 15:40:17 EDT 2013 | davef
Shear tests are [in my opinion] senseless. The shear stress you measure depends more on the shear rate and on the point where the force is applied than on the grain structure. When shearing a component, you not only apply shear stress, but also roll
Electronics Forum | Wed May 26 16:57:00 EDT 2010 | rgduval
Louie, We'd be interested in your experience with the stainless centering jaws. We just ran a job with heavy 0402 placements, and had a rough time with it. After much work on the package, magazine centering, etc, I've concluded the issue is the ce
Electronics Forum | Tue Jan 29 09:59:36 EST 2008 | ashley
hello Vikkaraja, your machine failed to pickup & centering test refuses to stop because the machine cannot determine which Head is currently at which station. on Head A, there is this little "dog" that cuts a sensor somewhere at station 9 on your ma
Electronics Forum | Fri May 31 19:39:43 EDT 2013 | hegemon
With zero knowledge and no internet degree on 3D printing... It seems to me to be a good use of the tech. I envision some CAD design work, "printing a sample fixture", testing it for fit, then sending the CAD file downstream to a CNC machine. Somet
Electronics Forum | Mon Apr 29 12:32:18 EDT 2013 | stephendo
Do you watch when it is doing the wave height test? Watch it and see if it goes up to the same spot on the test probe each time. If the test probe is dirty sometimes the solder has to go up higher on it before it gets detected. You might actually be
Electronics Forum | Wed Apr 28 21:59:29 EDT 1999 | KEVIN SIMPSON
Hi everyone, We started our first machine placed shield test today.We will be machine placing shields with in the next two months. I used a Fuji Qp242 today. There were no problems with pickup etc,. just vision errors. I'm sure we will work them ou
Electronics Forum | Thu Jan 10 15:32:54 EST 2008 | jdengler
A long time ago, in a place far, far away, I would test Fuji IP machines without the MFU's installed. They have a mechanical switch on the machine so it knows when a MFU is present. But what normally catches everyone is that the locking air cylin
Electronics Forum | Fri Aug 08 07:27:43 EDT 2008 | lonta96
Hi, I'm from a semiconductor package assembly, and currently looking for an offline solder paste inspector capable of true volume measurement. Any recommendation for a machine that can measure paste volume on a leadframe (metal substrate)? I found