Electronics Forum | Thu May 23 09:25:39 EDT 2013 | cyber_wolf
How many of you run a different oven recipe for the secondary side of a double sided reflow assembly. In other words, would you use the same recipe for both sides ?
Electronics Forum | Wed Oct 23 10:10:39 EDT 2013 | cano1912
Ryan, found the aligners form a company here in Florida called Island SMT. They carry a lot of spare parts for different machines.
Electronics Forum | Tue Jul 02 03:40:32 EDT 2013 | eniac
kumar, can you explain why in zones 5, 6 and 7 you use different temperature on upper and lower heaters? Do you use a Nitrogen in your reflow oven?
Electronics Forum | Wed Jul 03 03:02:35 EDT 2013 | autoel
How to test the reflow solder joint shear strength? What are the specification to test solder joint shear strength? What are the different methods to test the solder joint shear strength? Vijayashree
Electronics Forum | Sat Jul 13 17:38:20 EDT 2013 | ericrr
um thanks I have just got back into the settings and switched back on, for most of the time I have it switched on but now and again switch it off, just because "what is the difference?" at this stage I will never know.
Electronics Forum | Mon Jul 15 15:02:55 EDT 2013 | island2013
In previous lives we vacuum sealed all MSD devices. Also a nitrogen chamber can be used for unsealed bags. You can check the J-STD-033 and J-STD-020A for handling of the different levels, bake times etc. Good Luck!
Electronics Forum | Fri Jul 26 12:46:30 EDT 2013 | gallionc
I am not familiar with the ICOM 6000, but we have an ICOM 5000. It could be possible that your Resistivty probe is bad, or possibly disconnected? We've also had different errors that were simply caused by not having enough solution in the tank. J
Electronics Forum | Fri Jul 19 14:20:19 EDT 2013 | dontfeedphils
I'm at a different, smaller company now. I'm using YesTech now as well, but only as post reflow inspection later in the process, no pre-reflow.
Electronics Forum | Wed Aug 21 08:17:19 EDT 2013 | TB
We are just looking for something to get trainees familiar with the different polarity marking so they know what to look for.
Electronics Forum | Thu Jul 25 23:21:40 EDT 2013 | dekhead
1000ct encoder is the only one used on DEK Horizon (Typhoon Series); 2 different manufacturers, but interchangeable. http://www.dekhead.com
