Electronics Forum | Tue Jul 13 01:00:03 EDT 2004 | Shean Dalton
Cleaning RMA fluxes simply requires selecting a washing chemistry (either Solvent, Semi-aqueous or Aqueous) and an appropriate cleaning sytem. Your lot size would be easily handled with a batch system. visit http://www.aat-corp.com/Technical/Def
Electronics Forum | Fri Jul 30 01:13:27 EDT 2004 | yukim
Hi, We are based in Korea, a manufacturer of electronics for automotives. We are a small company, so no "corporative discount" is applicable to us. We currently have 2 SMT lines and are about to invest one more. Our production is high mix / low volu
Electronics Forum | Thu May 19 08:05:53 EDT 2005 | wigeon@telia.com
Hi, We are based in Korea, a manufacturer of > electronics for automotives. We are a small > company, so no "corporative discount" is > applicable to us. > > We currently have 2 SMT > lines and are about to invest one more. Our > production is
Electronics Forum | Thu Sep 09 04:51:19 EDT 2004 | Simon UK
65%), if one failed on the board i replaced all of them, and re-tested and thermally cycled them inline with our spec (-55/+80 Deg/C for 48hrs) this was a nightmare, especially when some cracks were not detected until several weeks later while flying
Electronics Forum | Tue Oct 19 22:51:07 EDT 2004 | KEN
I feel it is less pressure from consumers and more from stock holder increased demands for dividends. Every quaters end our publicly traded customers go bezerk on increased orders to show increased finished goods and less component inventory. All t
Electronics Forum | Fri Oct 29 09:45:08 EDT 2004 | pioneertechnology
In 1995 we bought 4 Vitronics U520 reflow ovens with top heat only. We ran these ovens until 2003 for both curing and lead reflow with no problems. In 1998 we bought 1 U520 top and bottom heat and one U820 top and bottom heat and once again we had
Electronics Forum | Fri Nov 12 15:56:50 EST 2004 | pdeuel
Thanks, That's the direction i'm headed. After by passing relay altogeather, testing large caps for the driver supply, replacing bridge rectifiers, and the MOV's, that's about all im left with. The vacuum motor will run with the software toggle witho
Electronics Forum | Fri Mar 11 18:30:50 EST 2005 | davef
Russ: In December 2003, the European Commission released the following statement: �The commission services have prepared a draft Commission decision establishing maximum concentration values pursuant to Article5(1)(a) of Directive 2002/95/EC. The pr
Electronics Forum | Fri Mar 11 18:47:54 EST 2005 | davef
JD: It's important to note that FR-4 does not contain PBB or PBDE. The bromine in FR-4 epoxy comes in the form of tetra-bromo-bisphenol A [TBBA], which polymerizes and become part of the cross-linked epoxy. Bromine, in the form of hydrogen bromide, i
Electronics Forum | Wed Aug 10 09:01:15 EDT 2005 | fctassembly
Hello Joseph, Sorry for the bad news but microcracking is a well known potential condition occuring with the SAC305 alloy. Microcracking is a condition being seen with many joints soldered with the SAC305 alloy. It is technically a shrinkage cavity