Electronics Forum | Tue Dec 11 12:29:57 EST 2012 | deanm
Thanks for the comments so far. The smallest nozzle I've tried is a 4mm, which is what Pillarhouse used on this board to provide a sample. I tried this but wasn't as good as the 6mm. I've soldered the same connectors on a different board using a 10mm
Electronics Forum | Fri Mar 29 16:57:07 EDT 2013 | aemery
Gentlemen, Just became a member and scanning the old posts hoping to help people out with their MPM printers. Most of this info is correct, the last post was the best. Offsets on an Accuflex printer can be put in either per process program or glob
Electronics Forum | Fri Apr 19 15:13:24 EDT 2013 | chifutbol
All right to expand on this, I've since learned a lot. On the computers running XP, I'm able to register a line no problem. Now I'm trying to get the Windows 7 computer to work. I have the windows virtual pc XP edition installed on here. I was ab
Electronics Forum | Fri Feb 01 19:12:18 EST 2013 | marcelorotofrance
Hi, I have a QUAD 4C mk2. I taught pickups and places from HHT. If I test them individually (RUN STEP PICK/PLACE etc...) before building the sequence, everything runs ok. After the sequence was built, everything goes wrong. Every PICK or PLACE ends i
Electronics Forum | Tue Feb 05 19:25:54 EST 2013 | swag
We have a few Bliss racks. They were made for 29x29 frames but we use them for vectorgaurd and foil. DEK ships vectorgaurd stencils in a nice, thin cardboard box. We use these boxes for storing vectorgaurd + foils. You can store a handful of foil
Electronics Forum | Tue Feb 19 08:08:29 EST 2013 | williamaxler
My company is starting to look into Conformal Coating Equipment. From preliminary talks it sounds like we would like to use a UV material. I have a few question I was hoping as a group you all would be able to pass along some insight. 1. Do any of
Electronics Forum | Mon Apr 08 07:20:56 EDT 2013 | leemeyer
What operating system are you using ? I have found that you need to stay with a DOS based operating system. I am running DOS 6.2 with windows 3.11. I tried win 98 and although it seemed to run properly, I would have problems in the final program. XP
Electronics Forum | Tue Apr 09 08:56:18 EDT 2013 | leemeyer
I made a new program today that will run on 2 machines and my AP did not create the 2 additional boards that you are speaking of. I'm not sure what thats all about. This is my method: 1. Set up a Assembler/system in AP that includes both machines tha
Electronics Forum | Mon Apr 29 13:56:19 EDT 2013 | williamaxler
We have a Versaflow 40/50 and ours is setup like this. We have out nozzle test position set so that in the Z axis you are 3.8mm away from the pin. Used feeler gauge Then you can set your gradient per nozzle. Start with a number then do a wave offs
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o