Electronics Forum | Wed Sep 10 07:42:52 EDT 2008 | lloyd
Can you provide a bit more info on your machine setup. I not full fimilar with the S-27 so a few points may not be relevant to your machine. Are you using Siplace Pro. Are you using the standard GF for the 0201 component. Do you have the component
Electronics Forum | Sat Nov 29 09:56:59 EST 2008 | blacksi27
What the other user was talking about is correct, converting it from gerber to machine cad. It is hard explaining programming SMT to a new user unless shown by another experience operator. I am also getting a topaz x pretty soon and I'll try to hel
Electronics Forum | Tue Oct 14 19:03:54 EDT 2008 | diesel_1t
currently we have a new Horizon 02i, new software "instinctive" is pretty easy to program and operator friendly, i love to work with proflow. Gridlock is not working so good as they told. I don't like that the paper doesn't roll while you're under cl
Electronics Forum | Fri Oct 17 14:26:39 EDT 2008 | hegemon
We use Mirtec MV-7s for post SMT inspection of solder joints as well. The artistry is in the program debug. We are very pleased with the solder inspections provided by these machines, and technology having advanced bit, most every AOI machine has t
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Fri Oct 09 06:53:10 EDT 2009 | taus
Hello, I've recently started to work with MPM AP25, I began doing maintenance to get to know the machine. But now I'm having some problems in the teaching process. You can see the problem in the photo. http://img59.imageshack.us/i/image194p.jpg/
Electronics Forum | Sat Oct 31 09:45:48 EDT 2009 | meritajs
Hello Jeffrey J I could share our experience in using used P& P machine type Philips (Yamaha) and Juki (Zevatech) We had three machines Philips (Yamaha) vintage about1990g, which work till now. They have same type of feeders, which is simple to find
Electronics Forum | Mon Nov 09 12:06:36 EST 2009 | cellis
I am sure I know which video you are talking about with the 7722-FV shaking. It is a video where the camera was on the table next to the machine. It was not a sturdy table to begin with. This was done by one of our customers in NYC. It does make
Electronics Forum | Thu Oct 29 21:16:15 EDT 2009 | mah115
Fellows, We are considering getting an AOI machine to inspect boards that our vendors are giving us (we outsource the assembly of PCBAs). We have low volumes of boards, but every time a defect does slip by our human inspectors, it causes a lot of
Electronics Forum | Mon Dec 21 12:09:21 EST 2009 | andrew_11
Hello Dany, i had been invloved in a evaluation at another company between omron,yestech,mirtec,vitech.. I found omron and vitech too long to program for hi mix low volumee. yestech and mirtec programmed quickly. I found the mirtec to find more of t
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723