Electronics Forum | Thu Mar 24 09:53:03 EST 2005 | aj
Doug, We are getting ready to do some trials at the moment. I have profiled the oven and achieved the Required Temps. that would be desirable. I dont envisage any problems what so ever aslong as who ever is doing the profile fully understands the
Electronics Forum | Tue Mar 29 13:14:28 EST 2005 | bobpan
Anyone familiar with making smema work on the ekra x5. I believe is was manufactured with a siemens (not smema)setup. We found the cables to make the siemens work but i am not sure if i can short a couple of inputs on the cable to make the smema func
Electronics Forum | Fri Apr 01 08:33:28 EST 2005 | tds
Please call me John & Michael. I am the Sales Representative in Ohio and I can help you both with each question you have regarding Technical Devices. My phone number is 330-724-3333 Thank you. Scott Wilson Tritec Sales, Inc.
Electronics Forum | Sun Apr 10 09:13:24 EDT 2005 | davef
The US automotive industry developed QS-9000. Look here: http://www.niubis.com/Quality/QMS.pdf Within that program is a set of tools and templates. It's possible that their "Advanced Product Quality Planning and Control Plan (APQP)" could help in
Electronics Forum | Wed Apr 06 07:28:54 EDT 2005 | liv2xplr
Besides the solder mask suppliers, I would contact some makers of exposure and alignment equipment. Try OLEC (www.olec.com) - they make different types of expsoure equipment. Another good source is a company called All-4-PCB (they rep a number of P
Electronics Forum | Wed Apr 06 09:16:31 EDT 2005 | blueflag
Ive just checked all the cables that i can see and there seems to be nothing wrong. Have just put a brand new fuse in to mot z card and it has blown it. machine boots up, initiate the hardware and everything goes ok until it does the z height then i
Electronics Forum | Thu Apr 07 08:02:44 EDT 2005 | Grant
Hi, I used to run a clean room, and it's right, most of the dust is created internally. You will need to add some HEPA filtering to the area, and an air handling unit that can control temp and humidity as well to get correct environmental control.
Electronics Forum | Mon Apr 11 02:58:49 EDT 2005 | Base
You might want to take a look at some of the Assembl�on/Yamaha stuff. I believe they have a machine that has a couple of dispense heads and a couple of placement heads, so you can get your solder-paste and component-placement all done in one machine.
Electronics Forum | Thu Apr 07 10:58:01 EDT 2005 | Dhanish
Need help from the experts on 1)simple way to measure the PCB warpage 2)what is the maximum warpage can the SMT machine allow the to accept and place the component without problem. 3)I have seen some people are using 7mils/inch as a Warpage spec. a
Electronics Forum | Tue Apr 12 22:23:05 EDT 2005 | Al
The way we do this, is to tape a transparent film to the PCB. The printers and chip shooters can read fiducials no problems. Once it has been run through SMT, simply remove the tranparency film and the PCB is ready for use, no mess no cleaning and yo