Electronics Forum | Mon Feb 25 03:45:57 EST 2013 | odedkal
Hi Davef, The question is which product is better ? Do you know if there is some kind of research regarding these (or maybe others)materials ? best regards, Oded
Electronics Forum | Tue Mar 05 11:51:36 EST 2013 | aj
Hi all, Would welcome comments relating to Hot Bar soldering... Best equip suppliers and things to look out for... Also, is there a machine with multiple heads instead of having to change heads for each different size? aj...
Electronics Forum | Tue Apr 02 12:51:46 EDT 2013 | emeto
I have seen it done exactly the way you do it and I think spraying will be better than dipping. However the best way is still to have your fluxer fixed and working.
Electronics Forum | Tue May 07 07:31:15 EDT 2013 | davef
Pavel You're correct that you should consider the point loading of your placement, wave and other machines. I've put shops above the ground floor of buildings. Equipment suppliers are the best source of information about these requirements. BR, dav
Electronics Forum | Thu May 16 05:47:12 EDT 2013 | trottmann
Hej AJ, i think in my case it was a weak connection at a light barrier. Best regards Tobi
Electronics Forum | Mon May 20 08:45:06 EDT 2013 | markhoch
Delta T usually refers to the Temperature Difference between adjoining zones in your Reflow Oven. The recommended Delta-T between heating zones is http://www.ipcoutlook.org/pdf/best_practices_reflow_profiling.pdf
Electronics Forum | Fri Aug 30 11:20:17 EDT 2013 | jth
Hi, contact me at joe@zntechnologies.com. ZN Technologies offers warpage measurement at room temp and during reflow using the superior projection moire technique. Best regards, Joe
Electronics Forum | Wed Jun 26 13:42:14 EDT 2013 | nucleus
Hi, we just bought a used dek infinity 265. Unfortunately we cannot find a programming manual. We have two big technical references and a operator manual. Is there someone who has a pdf-version of the programming manual? Thanks! Best regards mts
Electronics Forum | Tue Jul 02 21:18:23 EDT 2013 | kumar_antom
HI, She's running on air mode Since its a 7 zone japanese reflow,these were the best settings i could get via profiling Thank you
Electronics Forum | Thu Jul 04 17:17:00 EDT 2013 | processman
Hello, Hoping for some recommendations for how its best to selective solder clinched PTH components.. We are using Ersa equipment. Problem we are having is some of the leads are holiding `blobs` of solder on their leads. Have tried single dot