Electronics Forum | Fri Mar 05 15:43:10 EST 2004 | Quetza
You can have many problems, but the most commons are that your Z belt is too Lose or is time to replace it, the second is that your Z motor went bad. Hope these woks for you
Electronics Forum | Tue Mar 09 22:47:26 EST 2004 | pdeuel
Contact sensors out of adjustment. If you push up on spindle the led should change state. same if spindle is pulled down. I have also had problems with PTIF error during zeroing Soft stop. last messages recieved were reported as z axis time out durin
Electronics Forum | Fri Mar 19 12:18:27 EST 2004 | Primus
Isn't it funny, I just experienced that for the first time last night? We're always having tape clutch errors. Glad we're not alone on the Z-axis situation.
Electronics Forum | Fri Mar 05 00:53:09 EST 2004 | alwil
I have an Electrolytic capacitor which is 17mm in diameter and is 16.7mm in height. It is presented in a reel,44mm x 24mm. I want to know if there is a suitable feeder available to place this part onto a Fuji IP3. Thanks, Alan.
Electronics Forum | Mon Mar 08 22:04:19 EST 2004 | pari
Dave i know abt the JEDEC033A specs..but this question is more of PCBA level. The baking temp and time at JEDEC is for MSD devices. I have tried to check IPC 7711 but the criteria does not mention the baking temp and time. Wandering is anyone is awar
Electronics Forum | Mon Mar 08 07:29:53 EST 2004 | mrmaint
Sounds like you have some delamination problems. How hot is the board getting? Try baking the board prior to rework. Is the quality of the board good? Goog Luck. MrMaint
Electronics Forum | Wed Mar 10 00:25:36 EST 2004 | kanwal324
We have the expertise of mounting and rework of all types of bga without facing any problem. If you want or you can give us one oppurtunity. K S Walia Xo Infotech Ltd. India
Electronics Forum | Fri Mar 19 07:06:27 EST 2004 | george
Vijay: If you are still having difficulty or are frustrated with your yields try http://www.solder.net. They work on the most difficult packages and boards.
Electronics Forum | Wed Mar 10 09:20:20 EST 2004 | Robert
Thanks for the offer. However, I do not have access to the gerbers as I am only a low level personnel running the SMT line. I'll probably try and win approval for the purchase of a MOLE or datalogger and go from there. Thanks all.
Electronics Forum | Mon Mar 08 19:31:07 EST 2004 | Ken
Check out Indium Solder. They have an evaluation board "from Hell"!!! I believe they sell it for eval purposes...will supply cad data for stencil as well as pcb's for print test. I was stunned at the complexity. Hope this helps