Electronics Forum | Fri Apr 21 08:07:10 EDT 2006 | amol_kane
I struggled with the std too, when trying to justify the need for a desiccant cabinet. according to my interpretation: 1. the components are baked at 125 or 150 dec C within 24 hrs of manufacture (this is MET) and sealed in the MBBs at the component
Electronics Forum | Thu Mar 02 13:29:30 EST 2006 | russ
6 mils maybe? instead of 6mm? We go down to 5 mils and up to 7 with 0603. You could even use a 4mil stencil for these without any problems. The .2mm (.0078")apart however might get you in trouble unless your equipment is rock solid.
Electronics Forum | Mon Mar 13 04:18:42 EST 2006 | pedestrian
0.2mm gap between parts is small and easy to solder short. I prefer 5mils or 4mils.
Electronics Forum | Sat Mar 04 12:01:28 EST 2006 | slthomas
Slightly related story....my dad (vision not so good) put a gallon of WATER in with 4 gallons of cooking oil to deep fry a turkey. Of course the water was on the bottom and when it started boiling, whoooheeee!
Electronics Forum | Wed Mar 08 22:20:11 EST 2006 | pmperreca
I was wondering what type of machine would be the best for high production rate of small pcb boards. A rate of somewhere near 800,000 units a month on a board that is approx 1"x2" 4layer with 20 components.
Electronics Forum | Thu Mar 23 06:38:30 EST 2006 | pavel_murtishev
Good afternoon, We can use type-3 solder paste, but what for? Type-3 solder particles are larger than type-4. Probably this will cause even worse release. BR, Pavel
Electronics Forum | Thu May 25 16:12:13 EDT 2006 | steve_ucsd
I find it hard to believe that AIM never contacted you either by the rep or directly. I switched to AIM solder 4 years ago after using several of their competitor�s pastes for the very fact that the products were as good but Aim�s technical support w
Electronics Forum | Wed Apr 12 16:28:18 EDT 2006 | scombs
Has anyone out there have any experience with this product? It looks to good to be true. http://pkaymetal.com/dross.php4
Electronics Forum | Sat Apr 15 16:49:53 EDT 2006 | ausajid
hi we had also the same problem a time ago on the said package. we have taught his legs as 1, 3 and 5 instead of 1, 3 and 4 or 6. after doing this 98% problem solved. try this method...
Electronics Forum | Thu Apr 13 15:31:52 EDT 2006 | daxman
Yes, you are correct, no fiducial correction. If I force a fiducial correction, then the placement is alright. I should also mention that the placement gets worse as the production continues. I checked the lead screws and bearing holder...looks o