Electronics Forum | Mon Oct 21 09:41:42 EDT 2019 | mendezt6
Update: -The A12 tools will install in the 2nd machine. -Modified an A12 tool to install in the A13 tool location. -The modified tool will install in the A13 location of the 2nd machine, but not the 1st machine. Check that the parameters o
Electronics Forum | Tue Oct 22 21:24:02 EDT 2019 | richgreen01
Hi All I have the above machine and every day on start up i get the failed to initiate hardware message.I have been getting around this by re initiating the motor controllers and it is good to go after this.Does anyone know the causes of the initiat
Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit
It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower
Electronics Forum | Thu Oct 24 03:28:45 EDT 2019 | mfurlandea
Hello, i need an information about Fuji Aimex II and the problem when you have a multi offset pcb and you need to mount some offset with one program and the rest with a different program. So process dispense paste, mounting, changing program and moun
Electronics Forum | Thu Oct 31 11:47:00 EDT 2019 | slthomas
I've never tried OSP so can't speak to it's real world use. I only know what I've read about it (it has a shelf life and allegedly is less physically durable than ENIG) so I don't believe that it's a good fit for us. I understand that it solders
Electronics Forum | Thu Nov 07 10:07:02 EST 2019 | charliedci
Requesting help from anyone with experience in reflowing Te Connect, PN 1565917-4, 200 pin connecter. Pic attached. Cannot get all 200 pins to wet, main suspect is slight PCB warping during reflow. Have adjusted reflow profile. A 2.75 inch long SMT c
Electronics Forum | Fri Nov 29 10:26:01 EST 2019 | marwan
flux my leave a white residues even after cleaning, when we want to select a flux for our Ersa Ecoslect we tryed a varity of fluxes (including the IF2005C) and we decide to use the Cobar 390-RX-HT because he gaved us the best results in soldering and
Electronics Forum | Thu Nov 14 10:18:31 EST 2019 | slthomas
It doesn't look to me like the jumper wire is wetting at all. I would immediately question the solderability - do you know how that jumper wire is finished (plating type)? Also, how experienced are the solderers? It could be that the wire never get
Electronics Forum | Tue Nov 19 10:39:11 EST 2019 | cmchoue
Hi Experts, If SMT Type DDR DIMM Socket , PTH Pin size:2.5mm , PCB hole 2.45mm, Could this design can use placement machine to put DIMM on PCB? How to overcome the interference between PTH pin and PCB hole? Thank you Best regards James
Electronics Forum | Wed Nov 20 12:37:30 EST 2019 | compit
You bought quartz (at DigiKey), which should have 10 pF capacitors, and mounted on a demo board is from JFR - "(..) Load capacitance (CL): Series, 16pF, 20pF, 30pF, or specify (..)" - try changing the quartz capacitors, or check with an oscilloscope