Electronics Forum | Mon Aug 20 05:45:18 EDT 2012 | bobpan
To solve your problem....you should do the following: 1. Super Lube the o-rings on the z-rod bellows. 2. Make sure your head to camera calibration and head to head calibration is good. 3. Line up the nozzle changer pocket positions. 4. Make sure you
Electronics Forum | Sat Jan 12 15:37:33 EST 2013 | mwac
If the machine is printing with an offset on all products, then yes the printer needs to be calibrated with the fixture. That particular model requires the same tools as the 500 and 1500. They were different from other MPM machines of that or prior
Electronics Forum | Fri Mar 29 16:57:07 EDT 2013 | aemery
Gentlemen, Just became a member and scanning the old posts hoping to help people out with their MPM printers. Most of this info is correct, the last post was the best. Offsets on an Accuflex printer can be put in either per process program or glob
Electronics Forum | Mon Nov 04 05:22:14 EST 2013 | dselettronic
Good morning everyone I have read postings about Mirtec AOI, but they're not recent, so I'd like to know something about your experiences with Mirtec Benchtop MV-3. Our inspection department has now 3 MV-2HTL and we tried to make them as useful as po
Electronics Forum | Fri Apr 11 03:25:57 EDT 2014 | JB
Hello Len. Thanks for the update, I wouldn't say we are getting the hang of it but we are progressing, I now have a vision programming guide which isn't much help when parts are failing, it just states the obvious, set up sizes etc. The light that y
Electronics Forum | Thu Aug 20 15:19:49 EDT 2015 | superlen
JB, Thanks for the hint on the trimmer package "rough check" box, we have used it lately for some problem parts and it is indeed handy. -- On another Samsung question I have (slight thread hijack) Is anyone clear on how the "FEEDER" rotation sett
Electronics Forum | Tue May 27 15:11:13 EDT 2014 | dekhead
1. Rising Table Position error is, most commonly an issue of motor movement or sensor(s); Not receiving an expected input (sensor input / 'DONE' signal) in expected period of time. Try homing table in Diagnostics see if it moves and what movements ar
Electronics Forum | Mon Sep 15 14:14:47 EDT 2014 | riot983
Hi guys, New to the forum. I always read and look around at used equipment but have never posted. Anyway, I operate a Mydata My9 at a small shop and have recently ran into a problem and wanted to get some good advice. An employee of mine cleaned the
Electronics Forum | Thu Dec 04 10:59:02 EST 2014 | rrosera
HI, I work for a company in New England and recently had a unusually large number of boards fail after replacing a BGA on them. We use a AirVac DRS25 to remove and replace the BGA witch uses local forced hot air. We usually have at least a 90% s
Electronics Forum | Tue Feb 17 09:33:43 EST 2015 | emeto
Hello, I have two of these for the last 3 years(MV-7xi). Buy the machine with the best camera they offer and with the telecentric lens - it gives great view and resolution. I had to replace the controller for conveyer open/close on both of them. I a