Electronics Forum | Thu Jun 02 08:27:08 EDT 2005 | klukens
I agree with Steven. I have been involved with AOI for over 18 years. I was first introduced to it when I worked for Solectron. The AOI machines back then were more or less used as a selling item and very cumbersome to use. I have used and or operate
Electronics Forum | Wed Jun 08 04:08:35 EDT 2005 | SB
Lupo, Omron AOI systems are definitely the best and most accurate, with the exception of there desktop system which is poor in comparison. They used to be very expensive , but I believe their new models are well priced. If you want solder joint ins
Electronics Forum | Thu Jun 16 08:41:45 EDT 2005 | ghenning
Hi Fred, Were you able to develop enough confidence with the AOI to eliminate manual visual inspections and save money/time? How did you manage this and still get good solder joint quality? Thanks, George
Electronics Forum | Fri May 20 10:11:50 EDT 2005 | davef
Emerson Ventilation Products 10048 Industrial Boulevard Lenexa, KS 66215-1219 Phone: 913-752-6000 Fax: 913-752-6478 http://www.emersonvent.com
Electronics Forum | Sat May 21 07:51:08 EDT 2005 | jdengler
We would need more info to answer. How many boards get run between de-drossings? How many days between de-drossings? Are you removing dross only or some good solder with it? Jerry
Electronics Forum | Tue May 24 13:34:34 EDT 2005 | pr
We have done exhaustive studies and found the "smell and gag and kill operators" is acceptable and is more than offset by the solder saved!
Electronics Forum | Thu May 26 10:47:28 EDT 2005 | james
What is the highest temperature set at in your oven and your belt speed. Also what type of oven do you have? Thanks much. Your right about alot of heat needed. We actually see the outside balls much flatter and soldered compared to the middle bal
Electronics Forum | Thu May 26 13:04:44 EDT 2005 | c111
Can anyone recomend tools for cleaning & adjusting of a lead free solder pot? I know it's not recomended to use the standard stainless tools. I was told by an FSE to use wood (kitchen) tools. Thanks
Electronics Forum | Fri May 27 08:11:27 EDT 2005 | Joris Groot Koerkamp
I have a problem with a Murata cap chip type resonator(ROHS). After the reflow process, the soldering joints flow to one side of the component. I did not have this problem with the leaded component. Did someone have a solution for this problem?
Electronics Forum | Wed Jun 01 16:18:43 EDT 2005 | AlanJ
Prices are nice but the quality is very poor. I don't think they are at a point where they can manufacture quality equipment (soldering stations excluded) as it is mostly done on a low volume scale.