Electronics Forum | Fri Aug 12 08:13:12 EDT 2011 | rway
The only thing I see that might be a fuse is the green vertical axial leaded component next to the third from the bottom white 4-pin header. It's labeled ?718 or 710. I don't know if this is a resistor or a pico fuse. You can try to ohm it out. An
Electronics Forum | Tue Oct 11 09:26:42 EDT 2011 | dilogic
For all of you that are using this version of GSM USOS, I've made a patch that changes default fiducial repair drop-down menu from "Reteach Fiducial" to "Alignment Done". We had a large batch of boards with lousy fiducials and it drove me crazy havin
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s
Electronics Forum | Wed Dec 07 08:57:19 EST 2011 | edmaya33
5K with perform Head is amazing.You just need to make sure that during debug mode, the score should be 90%. Polarity, position, bridge, flip/tombstone/billboard, present/absent and solder condition ( and even OCR/OCV )is remarkable. Acceptance level
Electronics Forum | Mon Nov 21 10:56:32 EST 2011 | gosswald
I have been able to get the machine to run by using the teach feature in Central Controller. The fiducials coordinates are there from Auto Program even though they won’t run. Another problem I have with this is the board fails the visual inspection i
Electronics Forum | Tue Jan 10 19:01:13 EST 2012 | carvincorp
I was wondering if anyone else out there using the Vectorguard system by DEK has had problems with leaking air bladders. We started using a 29 x 29 frame about a year ago, and already, we've needed to send the frame back 3 times for repair due to int
Electronics Forum | Thu Mar 29 07:37:45 EDT 2012 | davef
The current discussion about solder fountains has to do with copper dissolution. Broadly, copper dissolution is the weakening of copper traces where a trace and a barrel plating intersect due a loss of the copper into the solder. Longer contact time
Electronics Forum | Wed Jun 27 11:58:42 EDT 2012 | cyber_wolf
Your tool tips are being damaged because the small x-motor is not engaging when the head is picking parts. When this happens the head overshoots and you bang the tips on the mag springs. Directly after a tip gets damaged go into the service program a
Electronics Forum | Sun Mar 03 15:01:47 EST 2013 | marcelorotofrance
Hi, I just returned from vacation, I left some unfinished business I should resume. Our Quad 4c has a broken Align head (I was able to diagnose this problem thanks to the help of mr. Bobpan). Just after my first posting, I was e-mailed by PPM and I r
Electronics Forum | Sat Jun 08 13:16:06 EDT 2013 | unisoft
Take a look at the Unisoft software ( http://www.unisoft-cim.com ). For over 25 years this software has in use by Electronics Manufacturer CEM/EMS's and OEM's to automate New Product Introduction (NPI). It's perfect for Electronic Contract Manufact