Electronics Forum | Tue Dec 16 06:42:51 EST 2003 | Kev
I am having problems achieving correct pre-heater temperatures with our Hollis solder wave. Our original "Verification Golden board" program uses a conveyor speed of 5ft per minute and pre-heat temps of 300, 350, 400 respectively. Our "golden Board"
Electronics Forum | Tue Sep 18 21:37:06 EDT 2012 | vergara1
Hi Manoel, I want to make sure I understand what you are talking about; reading the reply,along with your replys it almost sounds as if we are not talking about the same thing. In your picture I'm seeing a SMT diode correct? You are talking about th
Electronics Forum | Tue Jan 10 11:34:11 EST 2017 | charliedci
Have you contacted Speedline? They took over the Electrovert products and have provided us with parts and support on our 25 year old Econopak +.
Electronics Forum | Mon Apr 26 09:54:59 EDT 2010 | baildl632
What type of wave machine? Does your machine have a pump speed dial? Does your machine have the ability to raise and lower the pot? Raise pot to as close as possible to the pallets/boards and make sure they can pass over the nozzle without hanging o
Electronics Forum | Wed Jun 17 16:19:10 EDT 1998 | Ryan Jennens
| We are facing a problem of high contamination on boards after wave soldering. We want the contamination to be under 24 ugm/inch square. We are using a no clean flux with the spray fluxer unit of wave soldering. The contamination is higher on the e
Electronics Forum | Mon May 20 10:32:19 EDT 2002 | Hussman69
I actually built a dual tank fluxer for my Econo-Pak once to handle the same thing. Not all that difficult if you're mechanically inclined. BUT, for your application I'd recommend just hand spraying the 1 to 4 boards a month with any flux they reco
Electronics Forum | Tue Jan 17 06:45:29 EST 2006 | meritajs
Hi All, Could somebody help us to acguire manual or technical info for solder wave Electrovert Econopak and reflow oven HELLER 1500S Thank you Peter
Electronics Forum | Fri May 05 11:58:25 EDT 2000 | John Sims
We are using NR300F from Alpha. Topside board temp is 220 deg. F. We have 3 bottom side convection preheaters, and we use a foaming fluxer. The machine (except for the rotary chip wave) is almost identical to the old econopak. An electrovert appl
Electronics Forum | Tue Jan 20 21:37:26 EST 2004 | alwil
I am looking for a supplier or a manufacturer who can help me with Titanium Fingers for our Electrovert Econopak Plus wave solder. I am looking for the "v" groove type and also the 90 degree type fingers. I am in Australia. Thanks.
Electronics Forum | Wed Jun 02 19:31:01 EDT 1999 | Tony
| | | Dear All, | | | | | | We are a medium sized sub contract manufacturing house, engaged in high mix, medium volume production. We are using no clean as well as Aqueous cleaning process. we are planning to buy a new wave soldering machine out o
