Electronics Forum | Sat Nov 07 18:38:32 EST 2020 | enzik
Hello to all, The Fuji GSP III screen printer was working well yesterday. This morning, the machine turned on and the display screen was showing nothing. I went to the back of the machine and reset one of the VM1152A. The display screen is now showi
Electronics Forum | Thu Mar 20 17:26:14 EDT 2014 | dave222
I tried to check for the emitter and the receiver and I notice that the receiver is screwed into the side of the head and not easily accessible so I decide not to mess with it. this is what I did. I activated all of the clutches for the spindles an
Electronics Forum | Thu Dec 11 09:15:06 EST 2014 | sreejhu
Hello Sir, Thanks for your reply. i just got a mail from the DIMA service group and they said the Oven setting is as follows: Max temp settings in each zone (Which is not the temperature on your product, but close to where the air flow comes out of
Electronics Forum | Wed Aug 22 10:57:38 EDT 2001 | davef
I doubt that you�ll find a technical journal article that chronicles why a company selected one flux type over another. You might find some thing that sketches-out points to consider. As Cal says just because you ask an answer here, that doesn�t
Electronics Forum | Wed Dec 10 16:14:37 EST 2014 | jimpat
The 300 degrees is the temperature as measured at the sensor. The actual air temperature just above your PCB may actually be much less. If the oven is properly calibrated then the 300 should represent air temperature at the board but I have seen ma
Electronics Forum | Tue Aug 21 21:39:19 EDT 2001 | davef
1) why is No-clean (NC) the preferred process, for BGA mounting by SMT? Probably the same reason NC is the preferred process for mounting non-area array SMT components. 2) why is water-soluble (WS) not a hot choice? There�s not reason not to use
Electronics Forum | Wed Oct 08 12:49:37 EDT 2008 | leemeyer
When in the fiducial teach screen check to see if the "Fiducial Data from Autoprogram" box is checked. If this program was not generated from Autoprogram this box should not be checked.
Electronics Forum | Wed Aug 11 06:40:51 EDT 2010 | bob
If the fiducials are bad. There are 2 lights on the downward camera. The one that you can see is mainly used for bright and shiny fids....the other light is for dark/dirty fids. Turn this light on and set the other for 1 (not 0 because of a software
Electronics Forum | Tue Jan 24 10:48:52 EST 2006 | geb
Hi, We are starting to have supplied to us by customers different colour PCBs, which affects the ability of our MPM AP-27 stencil printer to see the fiducials. Has anyone tried and found out what the best and worst colours/ materials are for the fid
Electronics Forum | Wed Sep 17 10:28:05 EDT 2014 | travishemen
We had a Dek 265 LT that had a similar issue. We suspected it was a bad cable going to the camera as the issue always seemed to show up in the same X Y location. Have you tried swapping fiducial 1 and 2 to see if it is always the first fiducial or