Electronics Forum | Thu Feb 02 13:13:17 EST 2006 | MAZINK
Does any one know about QSV ! PLUS
Electronics Forum | Tue Mar 21 22:12:30 EST 2006 | bobpan
Leave an e-mail address....I can help you
Electronics Forum | Tue Mar 21 22:24:07 EST 2006 | alphaman
contact john.tate@alphatechnologyinc.com
Electronics Forum | Tue May 02 21:01:08 EDT 2017 | davef
PPM [www.goppm.com] is a good place to start. They help support SMTnet
Electronics Forum | Tue May 02 21:01:58 EDT 2017 | davef
PPM [www.goppm.com] is a good place to start. They help support SMTnet
Electronics Forum | Fri Jul 26 09:37:45 EDT 2019 | babe7362000
I got it BOB, just the TEP card needed seated more. Thanks
Electronics Forum | Fri Jul 26 15:12:28 EDT 2019 | bobpan
woohoo....good job.
Electronics Forum | Mon Oct 09 13:36:30 EDT 2006 | ppminc
Phil, The QSA-30 was built by Sam Sung, Sold by Quad. Single Head 2 Nozzles around 11K CPH Quad does not support the machine but I believe you can get parts direct from Sam Sung. I am not sure if they have a registration fee. The QSA used Quad made
Electronics Forum | Fri Jul 16 17:39:33 EDT 2010 | deanm
It is a PCB design issue where the copper patterns are not balanced among the layers. Baking the boards in order to correct the warpage will not improve it. We've had a problem with one bare board in particular warping the same way from two differen
Electronics Forum | Wed Feb 27 12:38:49 EST 2002 | stmerkt
Tyco has recently completed development work on the ThinPRO feeder. This feeder provides exceptional performance for 0201 and 0402 applications. The feeder is compatable with the IV-C, QSV, QSX, QSP-2, and APS platforms.