New Equipment | Industrial Automation
Contact: Sandy Lin Email:unity@mvme.cn Skype:onlywnn_1 Mobile(Whatsapp): (+86)-18020776786 QQ :2851195456 XIAMEN YUEHANG COMPUTER ENGINEERING CO.LTD Our services Packing & Delivery 1)100% full New! - Original Factory Seal ! 2)Warranty: 12 m
New Equipment | Industrial Automation
Contact: Sandy Lin Email:unity@mvme.cn Skype:onlywnn_1 Mobile(Whatsapp): (+86)-18020776786 QQ :2851195456 XIAMEN YUEHANG COMPUTER ENGINEERING CO.LTD Our services Packing & Delivery 1)100% full New! - Original Factory Seal ! 2)Warranty: 12 m
Industry News | 2018-12-08 03:29:29.0
SMT Dictionary – Surface Mount Technology Acronym and Abbreviation
Electronics Forum | Mon Sep 11 14:07:26 EDT 2000 | Steve
Hi ya'll!! We've got some PCB's in receiving inspection that has these little nodules in plating inside all of the barrels. These are microwave PCB's and have almost all of the surface area on both sides covered with with solid metal planes, and no
Electronics Forum | Wed Aug 21 17:03:13 EDT 2013 | hegemon
I think your pre-heat temp is a little low for SAC 305 Soldering. Especially with a Pallet. You might want to try to add some time and temp to get the PWB itself preheated up to 150-160C. That should help with the barrel fill. Make sure your board
Electronics Forum | Wed Aug 21 09:09:50 EDT 2013 | wcheew
I am having solder barrel fill issues on THM component, we follow, we follow IPC 610 E requirement. The barrel fill issues happen on signal & ground pin at connector & E-cap. I found out that most of the insufficient solder happen on the connector ag
Electronics Forum | Tue Jun 20 21:30:05 EDT 2006 | davef
The minimum vertical hole fill is defined as follows: Class 1: Not specified, with a 270-degree circumferential fillet and wetting on the secondary (solder source side) of lead and barrel, and a 75% coverage of the land area on the secondary side. Cl
Electronics Forum | Sat Aug 04 07:44:25 EDT 2007 | davef
Thermal cycle* * Requirements for and troubleshooting of poor barrel fill => Hole fill
Electronics Forum | Sat Aug 04 03:39:39 EDT 2007 | ahdo
Good day, can i seek an advice regarding wave soldering. Will it be advisable to reload the board two times to improve its barrel fill volume? If yes, what is the maximum number of times we can repeat wave soldering on the same board. If no, what
Electronics Forum | Fri Feb 21 19:41:25 EST 2003 | neil
I have had a look at what Bob Willis say's and the answer to my problem is not there. The paste we are using has a very high viscosity and I beleive that if we reduce the metal content to less than 90% it will solve the problem. The problem is parti
