Electronics Forum | Wed Apr 21 18:24:13 EDT 2004 | pjohnson@volterra.com
Simple process - we use similar Kester solder brands of "no clean" low residue solder wick to clean our pads, then brush with isopropyl, and apply Kesters brand of tacky flux under a Leica 6x microscope. We do this on 7x7mm and 9x9mm packages. This w
Electronics Forum | Fri Jun 18 10:59:37 EDT 1999 | Scott Cook
| A user of one of our components exceeded the floor life of some plastic BGA components. They did do a pre-bake prior to SMT reflow but only 72 hrs at 40C and not the recommended 12 hours at 125C. I've recommended accoustic microscopy to look for po
Electronics Forum | Fri Mar 29 17:58:21 EST 2002 | slthomas
We have a new assembly with bottom side components, and all the chip caps and resistors are 0603s. The dog boned shape of the caps necessitates a pretty big (and tall) dot to hold them still during placement, and when they get placed the dot squishe
Electronics Forum | Wed May 27 09:56:39 EDT 1998 | Chrys
| | | We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localize
Electronics Forum | Wed May 27 15:09:30 EDT 1998 | Dave F
| | | | We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not locali
Electronics Forum | Mon May 18 20:57:06 EDT 1998 | Earl Moon
.025" pitch so the only problem we run into is too much HASL on the adhesive side causing improper glue dispense. | As Earl keeps saying HASL thickness is hard to impossible to control. I think we need to look hard at OSP's again but then you get in
Electronics Forum | Mon May 18 22:54:04 EDT 1998 | Dave F
.025" pitch so the only problem we run into is too much HASL on the adhesive side causing improper glue dispense. | | As Earl keeps saying HASL thickness is hard to impossible to control. I think we need to look hard at OSP's again but then you get
Electronics Forum | Fri Mar 19 13:26:19 EST 1999 | Scott Cook
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Fri May 29 17:48:34 EDT 1998 | Earl Moon
| | | We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localize
Electronics Forum | Thu Mar 22 16:35:06 EST 2001 | Steve
Deja vu! When I read your response I turned around to see if you standing behind me listening to our problem. We currently make about 50 different boards all using no-clean that have no problems, yet this newest boards has a couple of issues that eng