Electronics Forum | Tue May 21 15:37:36 EDT 2013 | armelinda
I am looking for a service providing non contact PCB flatness measurement for open board SiP assembly. It was returned for failure analysis with complaint that assembly does not solder properly onto customer system board. Since there are remnants o
Electronics Forum | Thu Jun 13 08:53:25 EDT 2013 | markhoch
Ahhh yes. The infamous round rubber belts used on the Fuji CP2's and CP3's. :) I remember fondly using a pair of dykes and a Bic Lighter to make my belt repairs. Does anyone know if these are still available from Fuji? You may be able to find repl
Electronics Forum | Sun Jun 23 15:22:46 EDT 2013 | ericrr
Sorry I have not been back here to thank you for your response, I have not been back since my last posting, (for about 20 days). As a SMT operator it is the most horrible job I have ever had in the 40 years in the workforce, edit cut: I never got
Electronics Forum | Mon Oct 21 09:22:56 EDT 2013 | sara_pcb
One of our PCB for high reliability application is having 2 BGAs(11X11, ADV 204), The pitch is 1 mm. We decided to wire the BGAs first using re-flow soldering and the rest of the components by hand soldering. Since the PCBs are for high reliability a
Electronics Forum | Thu Jul 18 05:05:34 EDT 2013 | bobpan
Make sure that the lens is clean and you dont have any parts down inside on the camera. Also sometimes the leds that shine up to the part are bent in crazy directions. Make sure they look like they are all aimed up at the same direction. Is the brigh
Electronics Forum | Thu Jul 25 09:27:57 EDT 2013 | chris_flex
We are using some Hover Davis POD 600 at our site for label-placement. Since the feeder is no longer produced by hover davis , it`s always harder to get spares for those label-feeders. The supplier for this feeder-type in europe was pb-tec in germany
Electronics Forum | Wed Aug 07 16:56:32 EDT 2013 | marcelorotofrance
When I turn the machine on, almost every time I turn the Motor Power Switch it trips. I must to put the lever down and raise it again, then every runs normally. I asked to the former owner about that and told me that this machine always did it so and
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Thu Sep 19 10:15:36 EDT 2013 | sara_pcb
We have a PCB to be populated using reflow soldering. The board contains lead free BGA device(11x11, 1mm pitch ) and Standard SMT devices which are not lead free. Since profile temperature is different for both devices, our contract assembly house is
Electronics Forum | Mon Nov 04 12:18:12 EST 2013 | jimmyboz
Its been a couple years since I worked with Flexa every day. The program uses the part number and this should reference some shape library. If you understand the nomenclature of this library, it should get you close. I don't remember if the default