Electronics Forum | Tue Jun 23 08:08:38 EDT 2009 | ptxems
We have a couple of Zeva/Juki PM570L's. One machine has developed a fault with the z axis motor. It is continually 'buzzing', we have checked and there is 24VAC on it. Although even on the other machine there is AC voltage on the motor. We have sw
Electronics Forum | Wed Jul 08 06:02:59 EDT 2009 | stepheniii
Advertisements are not always 100% accurate on technical issues. You don't want instand static discharge. A wrist strap with no resistor could cause that. Therefore put in a current limiting resistor to make the charge dissipate slowly. Does anyone
Electronics Forum | Thu Jul 02 08:01:26 EDT 2009 | daxman
Good morning everyone, I'd really appreciate your input on some of the best ways to create a dry environment for MSD storage. Line down-time is considerable when we have to pull of and reload 20 reels of MSD parts at the beginning and end of each s
Electronics Forum | Mon Jul 06 01:27:06 EDT 2009 | mpolak
Hi Everyone, I am having some problems with pasting. When I print a board i expect the paste deposit to be brick shaped. Nice and square. The porblem is it higher on one side then on the other. And you can tell which direction squeegees were going b
Electronics Forum | Tue Jul 07 12:11:32 EDT 2009 | naynayno
We are in the process of transitioning from OA flux to No-Clean. Because of the tighter process window there is a lot of concern about component and PCB solderability and storage. The last thing we want to do is put some solderability specification
Electronics Forum | Tue Jul 07 15:02:48 EDT 2009 | snsmt
Hello everyone, I have a question regarding rework. How do you guys rework QFPs (lead free)? The only method that we are currently doing is using a heat gun. We are heating up the bottom of the PCB (approx. 2") away from the bottom of the
Electronics Forum | Tue Jul 28 01:39:32 EDT 2009 | Sean
Hi All, I have some question about flux residue resulted from non clean process as following: 1) Under what kind of circumstances that flux residue could appear? This residue does not happen during production but did appear after some period of ti
Electronics Forum | Thu Aug 06 21:50:19 EDT 2009 | fishingfool
Well Orbotech is basically out of business. They have sold their AOI to a company that is a basically a reseller. What that means is usually they have no people to improve software or make changes to improve the system. Not sure how Sony supports th
Electronics Forum | Tue Sep 01 16:40:50 EDT 2009 | jimprice9
I am the North American sales manager for Sony. This exchange was brought to my attention by an amused friend. The VR systems was marketed under the brand name Varir and produced by Sony Kohda. It was discountinued over 3 years ago. The CPC500 is
Electronics Forum | Thu Aug 13 12:23:39 EDT 2009 | robhs
Thanks Dave. What you say makes complete sense. We ran a job a short while back in this way (though without bonding) and found we had a much higher than normal failure of the BGAs which I can only attribute to the secondary reflow. As I have only got