Electronics Forum | Fri Dec 10 13:02:25 EST 2010 | gantry
You can try Tyco, they are the company who had that product line. Don't know what kind of support they offer for Kanetic anymore.
Electronics Forum | Fri Dec 10 14:11:56 EST 2010 | reic1
Thank you for the info. I tried them as the only website I could find was Kanetic.com which takes you to the Tyco site. They have little if no information. Thank you! Regards!
Electronics Forum | Fri Dec 10 11:36:44 EST 2010 | reic1
We just recently purchased a Dynapace 48" conveyor with digital display. Am in need of operation and maintenance manuals. Any assistance would be greatly appreciated. Thank you!
Electronics Forum | Fri Dec 17 09:42:55 EST 2010 | rwyman
User: Forgot Password: Restart Valid for TR2100 at least. Not sure of other models. Not sure if case-sensitive; that's how I jotted it down (1st letter CAP)
Electronics Forum | Mon Dec 13 11:27:39 EST 2010 | kvael
I have a Samsung CP30V machine that when starting up gives me the error "NO COMMAND RESPONSE FROM HANDLER". Has anyone had this problem. I have replaced the I/O Dpram board, no change.
Electronics Forum | Tue Dec 14 12:02:48 EST 2010 | tombstonesmt
If the blower is pulling high amps it's possible that it's still running but the oven is recognizing the high current. Check the label on the blower for the amp rating and check the current w/ an amp probe.
Electronics Forum | Tue Dec 14 15:07:51 EST 2010 | remullis
The bearings wear out on those blowers like a cheap pair of underwear. When you replace the bearings be prepared to see significant wear on the motor shaft also. We used to keep a backup ready to go. This will cause you to amp up higher than normal
Electronics Forum | Tue Dec 14 20:17:50 EST 2010 | sfsurama
I would be glad if someone could provide me the manual for Ekra E1/E2 screenprinter.. thank you
Electronics Forum | Tue Dec 14 21:25:30 EST 2010 | Jacki
Dear All In future, we will switch our process from Reflow Soldering to Vapour Soldering. Very appreciated if someone can share with me his experince in advantage and disadvantage of using Vapour Machine. Thanks in advance.
Electronics Forum | Fri Dec 17 02:35:05 EST 2010 | Jacki
Hi Hege Thanks. Now, we are doing an evaluation of vapour process with Rehm.Their system is injection the hot vapour into the chamber in where the PCB is placed. Rehm system is quite impressive and contrast from others. You can try.