Electronics Forum | Wed Apr 17 14:03:37 EDT 2002 | lysik
Pansonic is Real good about support once you have registered a machine. But They are in serious violation of the law if you have a part number and want to buy a part. In the USA a OEM must sell you parts no questions asked as long as you have a part
Electronics Forum | Wed Apr 17 18:18:52 EDT 2002 | bsteelglove
I recently bought a DEK 265 Mark 1 on the used market for $1,500 dollars along with a ABW 1210 Reflow oven which I really wanted. I knew the DEK had not been refurbed but that was fine because I was willing to pay there extremely high prices to have
Electronics Forum | Fri Apr 26 10:42:28 EDT 2002 | Jim M.
I worked for a telecom company that had sites in the deserts, jungles, mountains and regular built up area's. All boards were built using Aim 291/293 No clean solder paste. (all boards built to Bellcore standard) The boards were coated with Dymax ur
Electronics Forum | Wed May 15 22:23:38 EDT 2002 | ianchan
Hi mates, need some help to resolve a thumb-twine situation. As a high-mix, low volume prototype build house, we always conduct a first article inspection (FAI) on every model setup conversion in the SMT production Lot run. we do this FAI by mounti
Electronics Forum | Fri Jun 21 15:04:51 EDT 2002 | bentzen
Hi Greg. FujiCam has two ways of calculating the placement coordinate for a component. - The "FujiCam/Unicam way": calculating component origo as the center of the designed component pads. - Use the PCB designers part origo which could be center of
Electronics Forum | Mon Aug 19 20:44:01 EDT 2002 | davef
George: There is no industry standard for the calculation of process capability. Although, you should be aware of IPC-9850, Surface Mount Placement Equipment Characterization Actually, there is a grand bulk of discussion on process capability in t
Electronics Forum | Sun Oct 13 22:46:37 EDT 2002 | caldon
OK another nugget- Those not wanting to hear anything from a Rep do not read on.--------------------------------------- Lets not forget what has has made this forum successful (those who have not read or have forgotten): Who are we? SMTnet.com is
Electronics Forum | Mon Nov 11 11:42:26 EST 2002 | MikeF
Like Mark, I'm guessing your problem is with SMT parts on the top side, the solder is re-melting and some of the parts are moving around during when the board is being wave soldered. When I had some training on thru hole wave soldering way back when
Electronics Forum | Tue Jan 28 18:38:36 EST 2003 | joeherz
Mike, I've tried the high side of the flux preheat spec with no success. I did just get off the phone with Electrovert tech support...... Get ready. This machine is configured with a Contour Plus N2 nozzle. We are not running N2. According to M
Electronics Forum | Tue Apr 15 08:38:23 EDT 2003 | pjc
Don't have any specific links to papers and articles. Try searching on the IPC.org (plus APEX show http://www.goapex.org) and SMTA.org web sites. Any papers and articles on the process from equipment mfg.'s should be taken with a grain of salt. Sold