Electronics Forum | Wed Jun 13 16:09:28 EDT 2007 | rgduval
The parts were soldered in place on the first side. Any recommendations on material for this kind of fixture? I've shimmed boards off the belt before with titanium wave plows...but, I'd love to find something slightly more elegant.
Electronics Forum | Thu Jun 14 09:37:50 EDT 2007 | jdumont
Nice! Always love to hear people using the Trieber. Sadly, I had to retire mine in favor of a new Electrovert recently. Good luck with it...
Electronics Forum | Thu Jun 14 20:03:42 EDT 2007 | davef
If you're concerned, consider reducing the period used to monitor pot temperature in your process monitoring. Then, if you observe temperatures that ramp out of control more often than you expect, it might confirm the suspicion about damage to your
Electronics Forum | Thu Jun 21 07:21:26 EDT 2007 | chrispy1963
5 mil is perfect for 0402's. If you are printing SnPb solder use apeture reduction such as home plating the pads. However, if youre using SAC, we've found that printing the entire pad works best due to poor wetting compared to SnPb paste. Chris
Electronics Forum | Wed Jun 20 11:18:50 EDT 2007 | dboudreau
Hello, I have a question for electronic manufacturers. I would like to know in which cases a solderability test for component leads should be done? Should it be done for all kind of parts or only for those bought from brokers? Also, how often th
Electronics Forum | Sat Jun 23 09:56:04 EDT 2007 | slthomas
Every plant I've worked at used copper. I don't know your criteria for better, but I would think soldering and hanging copper would be a lot easier/quicker than threading and hanging iron. I haven't priced either one, though.
Electronics Forum | Thu Jun 28 13:36:49 EDT 2007 | carln
Permali is the manufacturer of Durostone pallet materials and they recommend the following methods: http://www.permali.com/pallets/PDF/Tech21.pdf http://www.permali.com/pallets/papers.htm
Electronics Forum | Fri Jul 06 12:39:01 EDT 2007 | blnorman
What's the metallization on the board? We use an immersion tin board and had to increase our profile to successfully solder.
Electronics Forum | Thu Jul 12 16:17:59 EDT 2007 | bandjwet
We are looking for: 1. A company that sells inspection equipment that can measure the height of solder balls (relative to the plane of the interposer or bottom of the device) OR 2. A service provider who can make some measurements for a user. Any
Electronics Forum | Fri Jul 13 12:27:30 EDT 2007 | jseagle
As in more dwell? We see the same problem with through holes connected to power or ground planes. The solder reaches the plane and stops. We are having our boards re-designed to increase the thermal relief and expand the hole size. We are also tr
.gif)
