Electronics Forum | Wed Dec 10 16:14:37 EST 2014 | jimpat
The 300 degrees is the temperature as measured at the sensor. The actual air temperature just above your PCB may actually be much less. If the oven is properly calibrated then the 300 should represent air temperature at the board but I have seen ma
Electronics Forum | Tue Dec 23 10:31:46 EST 2014 | jimpat
Sounds like your volumes are pretty low. Pick and Place is the bottleneck in the assembly line. Consider an oven that can keep up with the throughput of your P&P. "The best" is determined on individual cases for a specific application and enviro
Electronics Forum | Thu Jun 22 10:27:26 EDT 2000 | Igmar
Can someone please help with the aperture size on a Micro BGA stencil. I want to have an electroformed stencil made with 0.1mm (4mil) thickness. The PCB pad for the micro BGA has a 0.406mm (16mil) diameter. What size should I make the apertures for t
Electronics Forum | Thu Jan 04 12:10:50 EST 2007 | SMT Friend
When you do a google search, put quotes around your terms to only come up with pages that have exactly the terms you are looking for. For instance, my Google search came up with: http://www.google.com/search?hl=en&q=%22goldfinger+masking%22 which
Electronics Forum | Mon Oct 08 18:21:27 EDT 2007 | mariss
We have recently acquired a Passaat SMRO-0406 oven. The manual is uninformative for oven settings. Can someone supply us with starting points for conveyor speed, Zone 1 to 4 and 5 to 8 temperature settings please? Our boards for a product we manufac
Electronics Forum | Fri May 13 16:23:03 EDT 2005 | patrickbruneel
PR What you're up against is the usual bottom line manufacturing "cost" I have no direct experience with CEI, but I have experience competing with low labor cost. I have to disagree with Russ that Singapore cant handle high mix low volume because t
Electronics Forum | Thu Jun 29 09:29:46 EDT 2000 | JAX
sree, You might want to check the archives. If not, I found this just a few questions below yours!! [Back to thread listing at top] Posted by Igmar on June 22, 2000 at 10:27:26 AM EST Can someone please help with the aperture size on a Micro BGA st